How to adjust valves on 60 series detroit?
How to adjust valves on 60 series detroit?
To adjust the intake valves, insert a 0
How to adjust injectors?
Loosen the lock-nut of the injector adjusting screw with a ratchet and socket. Only loosen the nut two full turns. Insert an Allen wrench into the head of the adjusting screw and tighten to 40 inch-pounds. Loosen the same adjusting screw again with the Allen wrench by backing it off 3/4-turn.
How big is a Detroit Diesel Series 60?
Detroit Diesel Series 60 Dimensions approx 11.1 liter length: 56.6 in, 1437 mm width: 37.3 in, 947 mm height: 49.6 in, 1259 mm 12.7 liter length: 56.2 in, 1426 mm width: 37.5 in, 953 mm height: 49.6 in, 1259 mm 14.0 liter length: 56.2 in, 1426 mm width: 37.5 in, 953 mm height: 49.6 in, 1259 mm Click for Detroit Diesel Series 60 engine…
How tall is a DDEC Series 60 fuel injector?
FUEL INJECTOR HEIGHTS Models: 6067TKXX, 606XPKXX, 606XGKXX (1997-98 DDEC IV and later 1997 DDEC III) FUEL INJECTOR HEIGHTS Models: 6067EKXX, 606XBKXX, 606XMKXX, 606XLKXX, 606XHKXX, 606XFKXX (1998 & 1999 DDEC IV)
How to adjust intake valve height in Series 60?
Intake Valve Adjustment Loosen the locknut, and turn the adjusting set screw until the feeler gage produces an even smooth pull between the valve stem and valve button. Torque the locknut to 41 – 47 N·m (30 – 35 lb·ft) and remove the feeler gage. Reinsert the feeler gage to ensure that the adjustment did not change when the locknut was tightened.
Where are the intake valves located on a Detroit Diesel engine?
Each intake rocker arm assembly operates two intake valves in each cylinder. Each exhaust rocker arm assembly operates two exhaust valves in each cylinder. In each set of rocker arm assemblies, the exhaust rocker assembly is the widest, straddling the intake and fuel injector rocker arm assembly.
How big is the Detroit Diesel Series 60?
The Detroit Diesel Series 60 is an inline-six 4 stroke diesel engine produced since 1987. At that time, it differed from most on-highway engines by using an overhead camshaft and ” drive by wire ” electronic control. In 1993, it was popular on many USA buses in the 11.1 L (677 cu in) displacement.
What should I do for my Series 60 engine?
The tune-up procedure for the Series 60 engine consists of intake and exhaust valve clearance adjustments, fuel injector height adjustments, and Jake Brake® lash adjustments. These adjustments should be made with the engine cold.
What kind of engine does Detroit Diesel have?
The Series 60 engine is equipped with Detroit Diesel Electronic Control system (DDEC). Since DDEC replaces any mechanical governing devices, and the fuel injectors are electronically controlled, it is unnecessary to perform engine speed adjustments.
How do you troubleshoot a Detroit Diesel engine?
Insert a 3/4 in. drive breaker bar or ratchet into the square hole in the center of the crankshaft pulley. Bar the engine in the direction of rotation and observe the intake and exhaust valve rollers at any cylinder that is close to TDC (top dead center). See Figure “Valve Overlap Period” .
