How tight should my valve cover bolts be?
How tight should my valve cover bolts be?
Tighten until your hand can’t tighten anymore (which SHOULDN’T be too tight) And that should be just tight enough. Any tighter and you risk busting a bolt.
Are there any TTY bolts on Ford Explorer?
The jackshaft drive gear and cam drive gear retaining bolts are TTY (torque-to-yield) and should not be reused. If you don’t replace these bolts with new ones, there’s a risk of breakage. The rear jackshaft bolt is also covered by a small circular plug on the back of the engine.
What is the engine number on a 2001 Ford Explorer?
Kit number 2U3Z-6D256-AA is for balance shaft engines in 1999 to 2001 4×4 Explorer/Mountaineer, 2001 to 2002 4×4 Sport/Sport Trac and all 2002 Explorer/Mountaineer (except engine codes 2G-960-AA and 2G-964-AA).
When to replace head gasket on Ford Explorer?
Kit number 2U3Z-6D256-BA is for non-balance shaft engines in 1999 to 2001 2WD Explorer/Mountaineer and 2001 to 2002 2WD Sport/Sport Trac, and all 2001 to 2002 Ranger. If the head gasket is leaking, replacing the left head gasket can be done with the engine in the vehicle (assuming there is enough room to pull the head).
How to remove intake manifold from Ford 4.0L?
4. Disconnect the harness connectors to the fuel injectors, the engine coolant temperature sensor (ECT), the water temperature indicator sending unit, and the oil pressure sensor. 5. Remove both the valve covers and the valve cover gaskets as described above.
The jackshaft drive gear and cam drive gear retaining bolts are TTY (torque-to-yield) and should not be reused. If you don’t replace these bolts with new ones, there’s a risk of breakage. The rear jackshaft bolt is also covered by a small circular plug on the back of the engine.
Kit number 2U3Z-6D256-AA is for balance shaft engines in 1999 to 2001 4×4 Explorer/Mountaineer, 2001 to 2002 4×4 Sport/Sport Trac and all 2002 Explorer/Mountaineer (except engine codes 2G-960-AA and 2G-964-AA).
Kit number 2U3Z-6D256-BA is for non-balance shaft engines in 1999 to 2001 2WD Explorer/Mountaineer and 2001 to 2002 2WD Sport/Sport Trac, and all 2001 to 2002 Ranger. If the head gasket is leaking, replacing the left head gasket can be done with the engine in the vehicle (assuming there is enough room to pull the head).
4. Disconnect the harness connectors to the fuel injectors, the engine coolant temperature sensor (ECT), the water temperature indicator sending unit, and the oil pressure sensor. 5. Remove both the valve covers and the valve cover gaskets as described above.
