How much is a water pump for a 2000 Dodge Intrepid?
How much is a water pump for a 2000 Dodge Intrepid?
Dodge Intrepid Water Pump Replacement Cost Estimate. The average cost for a Dodge Intrepid water pump replacement is between $724 and $877. Labor costs are estimated between $585 and $738 while parts are priced at $139.
Why is my water pump leaking in my Dodge Intrepid?
I recently helped my sister-in-law by replacing the leaking water pump in her 1998 Dodge Intrepid with the 2.7L engine. It’s a terribly designed engine in that when the water pump shaft seal goes (as they are prone to do), the leak dumps coolant into the crankcase and fouls the oil.
What happens when water pump goes in Chrysler 2.7L engine?
It’s a terribly designed engine in that when the water pump shaft seal goes (as they are prone to do), the leak dumps coolant into the crankcase and fouls the oil. Chrysler seams to think that a simple weep hole is sufficient to catch any leakage and dump it outside, but, I’ve read too many stories about that being inadequate.
How is a hybrid water pump different from a regular pump?
Hybrid vehicle water pumps are electric, whereas traditional pumps are centrifugal pumps, driven by a belt or chain that is attached to the engine’s crankshaft. There are several warning signs for a water pump that is not functioning properly.
Where to find weep hole in Chrysler 2.7L engine?
BTW — the weep hole location is on the left side of the engine block, near the front, about half way up the block. It’s easiest to locate when looking from underneath the car.
Can a water pump be replaced on a Dodge Intrepid?
Now, here is what is involved and how to replace a water pump on a 2.7. This is not a job for the faint-of-heart, nor a job for those with no automotive knowledge. The car is a 2003 Intrepid with 73K miles. It began overheating randomly, and upon inspection I found water leaking from the water pump weep hole, just below the thermostat housing.
Where is the weep hole on a Dodge 2.7 water pump?
It would only leak at certain times. There are two weep holes on a 2.7, one is pictured, the other is below the lower intake manifold. If it leaks there, water will run out of the valley at the back of the engine and drip down around the transmission.
Where to put the sprocket on a 2.7 water pump?
Set your sprocket on the front of the camshaft, and let it float for now, with no bolts in. Line up the single plated link on your timing chain with the slot cut into the crankshaft sprocket.
What should I do if my water pump needs to be replaced?
Your oil pan will need to be dropped, the engine flushed out, and the rod/main bearings inspected and or replaced, or replacement of the engine with a rebuilt unit. Of course, check other places as well, including the water outlet, and the surge tank for cracks/leaks, and all the hoses.
