How much does it cost to install a transmission cooler?
How much does it cost to install a transmission cooler?
While installing basic rubber lines might work for most, in some cases, your vehicle may need custom lines, which are more costly than standard transmission lines. Depending on the cooler you purchase and your lines, you can spend as little as $20 extra to install a cooler, or in some cases, as much as $150 or more.
Do you need an inverted transmission line Cooler?
While some may argue that you need to install a certain type of cooler inverted to prevent air bubbles, the transmission line pressure it strong enough to push fluid through the entire cooler to prevent this. Should I Bypass My Radiator When Installing An External Transmission Cooler?
How are the cooling lines attached to the transmission?
The trite saying “think outside the box” is apt when discussing automatic transmission cooler lines. For our discussion simply know that two cooling tubes are attached to the transmission, the hot and cold lines mentioned earlier. One component inside that “box” is a small pump that circulates the transmission fluid.
Where is the best place to mount a trans cooler?
Based on this, the best place to mount a cooler would be in front of the air conditioning condenser. This position will allow the trans cooler to get ample air flow while moving in addition to getting air from the engine’s cooling fans when stopped.
What’s the best way to install a transmission cooler?
A can of cooler flush, which most shops have, followed by being blown out with air is the correct way to do it. When installing rubber cooler lines to metal lines always put a small flair at the end of the metal line Not too big because you will tear the line on the inside during install. Then place a clamp just ahead of the flair.
What are the lines on a transmission cooler?
Barb to Barb – Used to connect two rubber lines together. These fittings are common for when you install a transmission cooler and keep the existing rubber lines on the vehicle. This type of fitting is found on both the transmission and radiator where there is a pre bent transmission line.
Can a transmission cooler be in contact with the exhaust?
If the cooler lines were in contact with the headers, it would super heat the fluid when the headers get hot. Make sure there is no contact so you won’t have a problem. Always keep transmission cooler lines factory or otherwise as far away from the exhaust as possible.
Where does the oil come from in a transmission cooler?
If the oil flows from the radiator, this is the outlet. If the oil flows from the disconnected cooler line, it means the oil flows out of the radiator at the other cooler line, making it the outlet.
