How does the air conditioner work on a Jeep Liberty?
How does the air conditioner work on a Jeep Liberty?
The air conditioning system in your Jeep Liberty compresses a refrigerant and blows the resulting cold air into the passenger cabin.
How do you remove the battery from an evaporator?
Installation is the reverse of removal. Disconnect and isolate the battery negative cable. Recover the refrigerant from the refrigerant system as described in this group. Disconnect the refrigerant lines from the evaporator tubes. Install plugs in, or tape over all of the open refrigerant fittings.
How do you remove refrigerant from an evaporator?
Tighten the nuts to 7 N·m (60 in. lbs.) Connect the heater hoses to the heater core tubes. Unplug or remove the tape from the refrigerant fittings, and connect the refrigerant lines to the evaporator tubes.
How to install an A / C evaporator in a home?
Connect the rear floor heat duct to the center adaptor. Check that the carpet is not interfering with any duct outlets. Plug in the heater-A/C housing wire harness connectors. Install the instrument panel. Refer to Instrument Panel Systems for the procedures. Fill the cooling system. Refer to Cooling System for the procedures.
Installation is the reverse of removal. Disconnect and isolate the battery negative cable. Recover the refrigerant from the refrigerant system as described in this group. Disconnect the refrigerant lines from the evaporator tubes. Install plugs in, or tape over all of the open refrigerant fittings.
When to reset the Check Engine light after replacing an EVAP canister?
When a pressure issue is detected or excess vacuum is discovered in the fuel cell, the ECM detects the issue and triggers the Check Engine Light to come on. This light needs to be reset after replacing the EVAP emissions control canister if that is the source of the error code.
How do you remove an EVAP emissions canister?
Step 8: Remove EVAP canister from the clips (if applicable). In many cases this part is attached to a series of clips on the backside. You can gain access to these clips after you remove the bolts. Using a flat blade screwdriver, carefully depress on the clip and slide the EVAP emissions canister off the bracket.
Tighten the nuts to 7 N·m (60 in. lbs.) Connect the heater hoses to the heater core tubes. Unplug or remove the tape from the refrigerant fittings, and connect the refrigerant lines to the evaporator tubes.
