How do you set the steering box input shaft?

2. Rotate the steering box input shaft from lock to lock and set the box exactly half way between. For example, if the shaft rotates 3 full turns from lock to lock, the center will be at 1-1/2 turns from either locked position. 3.

What kind of shaft is used for steering column?

This column uses a 3/4”-36 splined shaft so a 3/4”-36 x 3/4”-30 splined rag joint is used. Both shafts are secured to the rag joint with the supplied set screws. TIlT COlumn WITH SHIfTeR 3/4”-36 SHafT fROm THe neW STeeRIng COlumn 3/4”-30 TO 3/4”-36 Rag JOInT PaRT #RJC-736730 ORIgInal POWeR STeeRIng SHafT 3/4”-30

Where can I buy a Dorman steering shaft?

Dorman steering shafts are distributed throughout North America and are available from most auto parts retailers and auto repair shops. You can search our site to see if we have the right fit for your vehicle, and then use the part number to search or ask for Dorman steering shafts.

What kind of coupler do I need for steering column?

The other end of the coupler will fit over the stock shaft, after you grind two flat spots in shaft to make the stock shaft into a 3/4” DD shaft. (See “Synchronizing Your Column” on page 7.) A 3/4”-36 x 3/4” DD coupler will be held to the column with set screws. The 3/4”-36 end will fit on the column shaft.

How do you replace a steering column shaft?

Remove the bolts that connect the coupler to the steering column shaft first. Then, further down, remove the bolts that hold the coupler to the steering gearbox input shaft. Then you can pull the steering shaft up and out. Reverse the procedure to install your new steering shaft.

What are the different types of steering shafts?

There are two main forms of steering couplers used: universal joints (u-joints) and rag joints. A u-joint can turn at an angle, which means that the steering shafts don’t have to be aligned in a perfectly straight line. If the shafts are lined up straight, they can be connected by a rubber disc called a rag joint.

Where are the universal joints on a steering shaft?

If you’re using a steering shaft that comes with universal joints, then, under the hood, by the firewall, pull back the rubber boot that covers the steering coupler. Remove the bolts that connect the coupler to the steering column shaft first. Then, further down,…

What causes a steering wheel shaft to come loose?

The joints can wear down overtime and become loose. That means that the input from the steering wheel isn’t perfectly translated to the steering box. It is also possible for the shaft to come loose from the joint as the shafts splines deteriorate.