How do you replace the steering box on a Chevy Silverado?

Disconnect the second, hard line to the power steering box. Use a wrench to loosen the nut, and then pull the line straight out. Remove the bolt on the coupler to the steering linkage. Remove the nut holding the Pitman arm to the steering box. Remove the Pitman arm using a Pitman arm puller.

How to change the power steering gear box?

Use a Motor FLush into the Power Steering PUMP.. Turn Engine on.. Let It FLOW and PUt one Quart of Cheap Power Steering Fluid. and Do it again.. Dump the Old Power Steering FLuid. Put a Prestone Power Steering Fluid. FInish..

How do you fill a Chevy 1300 steering box?

Mac Kinghorn: In a Motors Manual as well as a factory GM Service Manual that pertains to my 1952 Chevy 1300 pick up the instructions for filling the steering box are as follows: The steering box is to be filled through the pipe plug opening on the top of the box with the top sidecover bolt above the adjustment screw removed.

How do you remove a pitman steering box?

Remove the bolt on the coupler to the steering linkage. Remove the nut holding the Pitman arm to the steering box. Remove the Pitman arm using a Pitman arm puller. Remove the three steering box mounting bolts located in the driver’s side wheel well. Pull out the steering box. Figure 3. Remove the steering box.

When do you replace the steering box on a Chevy truck?

Replaces gear box with casting number of 5698180 and was used in many GM 2wd pickups from 1967-86. Can also replace Dodge 3496910, but alignment flat may not… Reproduction power steering box for 1968-75 Chevrolet and GMC 4X4 trucks.

How do you replace power steering on a Chevy Silverado?

Disconnect the second, hard line to the power steering box. Use a wrench to loosen the nut, and then pull the line straight out. Remove the bolt on the coupler to the steering linkage.

How to replace power steering pump on 2005 Chevy?

(Playback ID: liuP2t0pZgH__7B7) An error occurred while retrieving sharing information. Please try again later.

How do you remove a power steering box?

Disconnect the rubber line to the power steering box using a pair of channel pliers. To do so, squeeze the clamps together and pull the line straight out. The line will leak fluid, so be sure to have a drain pan ready. Disconnect the second, hard line to the power steering box. Use a wrench to loosen the nut, and then pull the line straight out.

Can a power steering pump be replaced on a Chevy Silverado?

The power steering pump in your truck runs off the engine, and serves as a hydraulic assist for the steering rack. Although power steering pumps are prone to wear and may eventually fail, they are not very complex components and moderately easy to replace.

How do you replace the drive belt on a Chevy Silverado?

Attach a 15mm socket with ratchet and extension to the center bolt of the tensioner pulley. Rotate the bolt clockwise until enough tension on the drive belt is relieved. Then, remove the drive belt from all of the pulleys. Figure 6. Release the tensioner pulley.