How do you remove water pump from engine?
How do you remove water pump from engine?
Remove the water pump mounting bolts completely from the water pump. Pull the water pump off the engine, and allow the remaining inner engine coolant to drain into the pan. Scrape the water pump mounting surface using a straight razor blade. Remove the old gasket material and residue from the water pump mounting surface.
How do you remove a drive belt from a water pump?
Loosen the three mounting bolts on the front of the water pump pulley using a ratchet and socket. Do not remove the bolts completely. Depress the belt tensioner assembly by placing a 3/8-inch-drive ratchet into the provided hole at the top of the tensioner. Remove the drive belt from the engine completely.
How do you remove a water pump pulley from a truck?
Raise the front of the truck off of the jack stand, then remove the stand from beneath the truck. Set the S-10 back on the ground. Loosen the three mounting bolts on the front of the water pump pulley using a ratchet and socket. Do not remove the bolts completely.
How do you replace a water pump sprocket?
Remove the thermostat housing and pipe from the water pump. Remove the water pump and install the replacement, after the bolts are in place to hold the sprocket to the water pump the tool can then be removed. Re-install all other components to complete the job.
Remove the water pump mounting bolts completely from the water pump. Pull the water pump off the engine, and allow the remaining inner engine coolant to drain into the pan. Scrape the water pump mounting surface using a straight razor blade. Remove the old gasket material and residue from the water pump mounting surface.
Raise the front of the truck off of the jack stand, then remove the stand from beneath the truck. Set the S-10 back on the ground. Loosen the three mounting bolts on the front of the water pump pulley using a ratchet and socket. Do not remove the bolts completely.
Loosen the three mounting bolts on the front of the water pump pulley using a ratchet and socket. Do not remove the bolts completely. Depress the belt tensioner assembly by placing a 3/8-inch-drive ratchet into the provided hole at the top of the tensioner. Remove the drive belt from the engine completely.
How do you install a water pump on a car?
Press the pump with slight pressure against the engine mounting surface. Install the water pump mounting bolts and tighten them snug with a ratchet and socket. Tighten the mounting bolts to 18 foot-pounds using a 1/2-inch-drive torque wrench and socket. Install the water pump pulley, and tighten the pulley bolts snug with your fingers.
How do you install a water pump on a truck?
Tighten the mounting bolts to 18 foot-pounds using a 1/2-inch-drive torque wrench and socket. Install the water pump pulley, and tighten the pulley bolts snug with your fingers. Depress the belt tensioner and install the belt using the diagram on the truck or the one you drew.
