How do you remove the seat on a Harley Davidson?
How do you remove the seat on a Harley Davidson?
To remove this use a T40 Torx wrench along with a 13mm socket wrench from the inside of the fender. Proceed following the same steps for the other side of the bike. Next, remove the seat screw which is highlighted in the picture below. After removing the seat you will see all the cables of the rear lights.
How to install and remove window regulator 741-644?
STEP 1d: Disconnect electrical connections to switch. STEP 1e: Gently pry around door lock bezel and unsnap it from door panel. Unclip from door lock rod and remove. STEP 1f: Using a 7mm socket, remove the 3 highlighted screws. STEP 1g: Lift trim panel up and remove from door. INSTALL/REMOVAL INSTRUCTIONS: WINDOW REGULATOR 741-644
How to install a side mount license plate?
We can now move on to the next section which is how to install the side-mount license plate kit. Before moving on with the installation, here is the installation instructions shipped with the kit. Okay, now take the license plate mount you see here. And take the kit provided LED light and screw it using a Torx T20 wrench.
How do you remove a window switch regulator?
Removal Instructions STEP 1: Gain access to the window regulator assembly by removing the interior trim panel. STEP 2: With interior panel removed, peel back the plastic water barrier enough to be able to remove the regulator. STEP 3: Reconnect the window switch electrical connector.
How do you remove a side view mirror?
Step 7: Pull the actual mirror apart from the mirror assembly. You can do this using a torx driver to remove the screws and then steadily pry the plastic tabs on the backing until the two pieces come apart.
How to install an exterior door on vinyl siding?
1 Trace the outline of the moulding onto the siding. 2 If you have vinyl or metal siding, be sure to enlarge the outline to make room for the extra trim required. 3 Remove the door and frame after finishing the outline.
How do you install a new front door?
Install a new door lock and door knob by inserting the latch through the hole for the new parts. Insert the lockset tailpieces through the latch bolt, and screw the handles together by tightening the retaining screws. Avoid damage to the screws by using a hand screwdriver.
