How do you remove leaf spring shackles?
How do you remove leaf spring shackles?
How to Change a Leaf Spring Shackle
- Place a floor jack under the rear differential of your vehicle and raise it off the ground.
- Lower the jack and allow the suspension to droop, taking the weight of the vehicle off the shackle.
- Remove the lower mounting bolt from the shackle and spring using a socket and ratchet.
How do you remove bolts from rear leaf springs?
If there’s not enough room to drive them through, grind or cut off the bolt head and try going the other way. Use a Sawzall to cut the bolt inbetween the bushing and the shackle/spring hanger on both sides. Once you get the spring out, use a press to push the bushing out.
How do you remove a shackle pin?
Just go carefully and don’t break any drill bits. Then make up a simple slap hammer to pull the pin out, or like an axle, a 6 foot length of heavy chain hooked to a smaller chain attached to the shackle pin. Snap the chain like a whip and it may pop that stud out like a coannon shot.
What’s the best way to remove frozen shackle bolts?
Torch is not a bad idea, dunno if ‘pane will get hot enough to break up the corrosion between the sleeve & bolt- it will get hot enough to catch your shackle bushing on fire though. Be careful. If you’ve got new bolts, cutting isn’t a big deal (I’d use a sawzall). 1. PB blaster. All over. 2.
Why are two of my shackle bolts stuck?
Two of the bolts are stuck in the spring bushing. I am beating the hell out of them with a BFH, but progress is slow. They are not bearing any weight so they are not bound up because of that. There has to be an easier way! Thanks in advance. propane tourch! hardhat.. Likely they are seized in the metal sleeve inside the bushing.
How do you get bolts out of leaf bushing?
Please try again later. Getting stuck bolts out of leaf spring bushings without destroying the bushings. Jack your truck up, stands under the frame in front of the rear leafs, then lower the rear axle to its lowest, then just raise rear axle a tiny bit. Aim for as little load on leaf spring bolts as possible. Get them bolts out.
Why are my CJ shackles stuck in spring?
Trying to replace the goofy 7″ long shackles on my CJ. Two of the bolts are stuck in the spring bushing. I am beating the hell out of them with a BFH, but progress is slow. They are not bearing any weight so they are not bound up because of that. There has to be an easier way!
