How do you remove an instrument cluster from a Chevy S10?
How do you remove an instrument cluster from a Chevy S10?
Adjust your tilt steering wheel as low as possible, and shift your gear shift to the lowest possible gear to give you plenty of room to access and remove your cluster. Remove the interior trim surrounding the cluster by prying it out of its clips using a flat screwdriver or trim removal tool.
How do you remove the dash from a S10?
Remove the two retaining screws for the instrument cluster bezel, which are accessible from the underside above the cluster. Pull the trim bezel off the panel, unplug any electrical connectors behind it, then pull the bezel back sharply to remove its clips from the panel.
When did the Chevy S-10 pickup truck come out?
The Chevrolet S-10 is a compact pickup truck from the Chevrolet marque of General Motors. It was the first compact pickup of the big three American automakers. When it was first introduced in 1982, the GMC version was known as the S-15 and later renamed the GMC Sonoma.
Can you change the odometer on a Chevy S10?
Depending on which one you select, you may have the odometer pre-programmed with your S10s current mileage so that it matches when you receive it. If you are not able to transfer over the mileage, note the discrepancies and obtain the appropriate affidavits, depending on your local Department of Motor Vehicle laws.
Adjust your tilt steering wheel as low as possible, and shift your gear shift to the lowest possible gear to give you plenty of room to access and remove your cluster. Remove the interior trim surrounding the cluster by prying it out of its clips using a flat screwdriver or trim removal tool.
Remove the two retaining screws for the instrument cluster bezel, which are accessible from the underside above the cluster. Pull the trim bezel off the panel, unplug any electrical connectors behind it, then pull the bezel back sharply to remove its clips from the panel.
How do you remove parking brake from S10?
Remove the knee bolster’s remaining screws and lower it from the instrument panel. Disconnect the release cable for the parking brake and and unplug any other connectors before removing the bolster. Remove the two retaining screws for the instrument cluster bezel, which are accessible from the underside above the cluster.
How to change a broken speed sensor on a Chevy S10?
Turn the ignition switch to the “Lock” position and remove the key. Disconnect the negative, black battery cable using a wrench. Remove the air bag fuse from the fuse block located inside the engine compartment. If there are more air bag fuses, remove them as well. Consult your car owner’s manual, if necessary.
