How do you remove a light switch from a Thunderbird?
How do you remove a light switch from a Thunderbird?
The switch can be moved forward then dropped down from the dash enough to disconnect the wiring and remove the switch. The lighter assembly can be removed by going under the dash to disconnect the power wire, then turn the sleeve housing (under the dash) counter-clockwise to remove it.
How do you remove a headlight control switch?
We’ll start the removal procedures with the headlight control switch. The first step is to remove the Headlight knob and shaft from the headlight switch unit. Removing the knob and shaft will provide access to the headlight retaining bezel.
How do you remove the radio from the dash?
Push the radio forward; drop the end down, and rotate the radio assembly to remove it from under the dash. The heater control is held in place from the back side of the dash by two retainers, one on each side, as shown in photo #6.
How do you remove the heater on a Thunderbird?
With these items removed insert the small end of the bezel tool (photo #4) over the shaft and engage the bezel nut, turn counter-clockwise to remove. The cable assembly can then be removed by pushing the shaft housing forward and out from under the dash. The heater on/off switch is removed in the same manner.
How do you remove a dash panel on a Ford?
Determine which panel you need to remove and slide your fingers into the air vent located in that panel. If you are removing the bezel around the stereo and environment controls, look to the bottom or top for a lip you can grip with your fingertips.
How do you remove the headlight shaft on a Thunderbird?
Photo #3 shows the Headlight knob and shaft after its been removed. With the shaft removed, the retaining bezel can be removed with the special tool by inserting the small end of the tool in the bezel slot and turning counter-clockwise.
The switch can be moved forward then dropped down from the dash enough to disconnect the wiring and remove the switch. The lighter assembly can be removed by going under the dash to disconnect the power wire, then turn the sleeve housing (under the dash) counter-clockwise to remove it.
How do you remove the dashboard on a 1964 Ford Thunderbird?
Next, remove the trim at the base of the center console.…and the lower trim panel on the passenger side. Parts of this are stapled on. In retrospect, this may be fine to leave in place:The left radio access panel comes off (Mine is riveted to the trim panel supporting the ignition switch. The manual says it’s screwed together.
Determine which panel you need to remove and slide your fingers into the air vent located in that panel. If you are removing the bezel around the stereo and environment controls, look to the bottom or top for a lip you can grip with your fingertips.
Photo #3 shows the Headlight knob and shaft after its been removed. With the shaft removed, the retaining bezel can be removed with the special tool by inserting the small end of the tool in the bezel slot and turning counter-clockwise.
Where is the heater control located on a Thunderbird?
The heater control is held in place from the back side of the dash by two retainers, one on each side, as shown in photo #6. First remove the three wire control cables from the control levers, note the color code wire band on the end of each cable tubing shield so that you can replace them in the same positions.
How do you remove the air vent cable on a Thunderbird?
The heater on/off switch is removed in the same manner. The left air vent cable is removed by first removing the retainer clip and cable end from the flapper valve lever in the engine compartment. Next go under the dash and remove the retainer nut from the cable.
How do you remove the control knob on a Thunderbird?
Then remove the control knob by loosening the knob set screw; the knob can then be pulled off the shaft. With these items removed insert the small end of the bezel tool (photo #4) over the shaft and engage the bezel nut, turn counter-clockwise to remove.
