How do you release the foot parking brake on a Ram 1500?
How do you release the foot parking brake on a Ram 1500?
The Ram 1500 does have a release lever, but it’s built to look like a part of the truck’s trim. You’ll find it directly above the parking brake. JuSTStick Your fingers behind the “dashboard trim”, and pull forward., This is the parking brake release, and pulling it will disengage Your parking brake.
How do you install park brakes on a Dodge Ram?
Check the rear brake shoe adjustment with standard brake gauge. Install the rotors and verify that the rotors rotate freely without drag. Install the wheel. Lower the vehicle enough for access to the park brake foot pedal. Then fully apply the park brakes.
What kind of brake system does Dodge Ram have?
There are light- and heavy-duty brake packages. The light-duty package for the 1500 uses floating dual piston calipers in the front and single piston floating calipers in the rear. The fourth generation Dodge Ram is probably one of the most trouble-free brake systems you’ll see.
How much torque does a Dodge Ram have?
Servicing the pads and rotors is simple, typically with few surprises. The torque specifications for the light-duty package are 130 ft/lbs for the front caliper brackets and 120 ft/lbs for the rear caliper brackets. The heavy-duty front brake caliper bracket has a torque specification of 275 ft/lbs.
Are there brakes on a Dodge Ram 1500?
This article applies to the Dodge Ram 1500 (2009-Present). Truck brakes usually get to see higher levels of use and wear than many normal cars. Trucks tend to weigh more than your average vehicle; this means that the brakes have a lot more weight to halt than a regular economy sedan.
What causes a Dodge Ram 1500 to speed up?
The gas and brake pedals are fairly close together and if your foot is off set on the brake pedal, your shoe will catch the gas pedal when pressing down on the brake pedal. This will cause the engine to speed up while you are trying to stop the vehicle.
Do you have to change the front and rear brakes?
If you are going to change the front brakes you must change both sides. If you are going to change the rear brakes you also must change both sides. If you only change one side, then you will get uneven braking performance from your brakes, and this could make your truck very difficult to control.
How do you install a new brake rotor?
Install new brake rotor. Install brake caliper mounting bracket and bolts. Install anti-rattle clips. Install brake pads. Attach brake caliper banjo bolt (if removed to install new caliper). Slide caliper into place over brake pads. Install bolts that secure caliper to caliper mounting bracket. Bleed brakes (If brake line was loosened).
