How do you reinstall a cruise control module?

Two screws secure the Cruise Control Module. Use a number 3 phillips bit. Reinstalling the vent duct requires pressing it over another section of duct. Put a rod, like a socket extension, across the throat of the duct, reach under the dash to grab the earlier section of duct, and push it on.

Where is the cruise control module on a Eurovan?

The cruise control module is the small silver box above the glove box. It is said to be almost impossible to access. The trick is to remove two bolts with a 10mm wrench that hold the shelf the glove box is mounted on. Refer to this article for repair tips for this older module:

Where is the cruise control module located on a 1997 Ford Focus?

The Cruise Control Module is located under the right side passenger AC vent. Photos in this article illustrate the 1997 → 2001 configuration.

Is there a turn signal for cruise control?

This combination cruise control, wiper, high beam and turn signal switch lever is a new, aftermarket replacement part. It is designed to REPLACE original units that are prone to failure. It’s just what you need to get your vehicle in good working order again! Specifications:

Where is the intermittent wiper control located on a car?

A partial or complete loss of intermittent wiper control. To fix these two problems, you’ll need a shop manual, a digital multimeter and possibly some Torx bits. On most late-model vehicles, the MFS is located under the plastic covers behind the steering wheel.

How to fix intermittent wiper and turn signal problems?

Disengage the plastic snap clips and separate the two halves of the steering column cover. Multifunction switch levers control headlights, flashers, wipers and intermittent windshield washers. The MFS is usually held in place by hex-head or Torx screws. Remove them, pull out the switch and disconnect the electrical connector.

Why do you need a windshield wiper arm turn signal lever?

It is designed to REPLACE original units that are prone to failure. It’s just what you need to get your vehicle in good working order again! Specifications: This combination lever is designed to replace your original with no modifications necessary.