How do you put fog lights on a Dodge truck?

How do you put fog lights on a Dodge truck?

Now that this is done, you can install the fog light bulbs and run the fog light wiring harness to each light. Plug the wiring harness into the connector under the core support and route the fog light plugs to each fog light. The longer side of the wiring harness goes to the passenger side fog light.

How to add fog lights without factory fog?

Once the box is laid over, locate the LB (Light Blue) wire and the BR/WT (Brown w/ White Stripe) wire that goes into Fog Light Relay #2. These are the only 2 wires that you will need to run wires from to the factory fog light switch in the dash. Now, with most of the under hood work done, lets continue inside the cab.

Do you have to drill new holes for fog lights?

If it does not, you may have purchased the incorrect headlights. Make sure that the bolt holes line up; otherwise you may have to drill new ones. Insert the bolt.

Where are the factory fog light relays located?

First, make sure that you have the 2x factory fog light relays located in the under hood power distribution box. The 2x pictures below show the location of the relay’s and the fuse. The next step is to make sure that you have the wiring harness needed under the radiator core support to plug in the factory fog light T wiring harness.

How do you install a fog light on a car?

Insert the bolt. Thread the washer and nut over the bolt, tightening with a ratchet or wrench. Do not over tighten as you may damage the fog light housing or the vehicle. The housing should be snug and immobile. Reattach the switch. Reconnect the fog light switch using the clip.

If it does not, you may have purchased the incorrect headlights. Make sure that the bolt holes line up; otherwise you may have to drill new ones. Insert the bolt.

What are the restrictions on installing fog lights?

Check your local laws. Some areas have restrictions on the type and color of lights you can install. Check your local regulations to make sure that your new lights are in compliance. Not all fog lights are approved for road use by the Department of Transportation.

Do you need to cut bumper cover for fog lights?

If your vehicle was not equipped with fog lights from the factory, it’s a good chance the bumper cover already has openings for them or pre-defined cutout areas marked on the inside. Vehicles that have nothing at all will require measuring and cutting by eye.