How do you open the hood on a 2009 Volvo S40?

Opening the hood Pull the lever near the pedals to release the hood from its fully closed position. Turn the handle under the front edge of the hood counterclockwise to release the catch and lift the hood.

Where is the bonnet catch on a Volvo V40?

The bonnet can be opened when the handle in the passenger compartment has been turned clockwise and the lock by the radiator grille has been moved to the left. The handle for bonnet opening is always on the left-hand side. Turn the handle about 20-25 degrees clockwise. You will hear when the catch releases.

When did the second generation Volvo S40 come out?

In this article, we consider the second-generation Volvo S40, produced from 2004 to 2012. Here you will find fuse box diagrams of Volvo S40 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011 and 2012, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout).

Where is the fuse box on a Volvo S40?

Here you will find fuse box diagrams of Volvo S40 2004, 2005, 2006, 2007, 2008, 2009, 2010, 2011 and 2012, get information about the location of the fuse panels inside the car, and learn about the assignment of each fuse (fuse layout). The fuse box is located under the glove compartment. 1. 2. 3. 4. 5. 6. 7. 8 . 9. 10 . 11. 12. 13. 14. 15. 16. 17.

Where are the terminal resistors on a Volvo S40 / V50?

Note that the S40/V50 does not have a Upper Electronic Module (UEM) or a Rear Electronic Module (REM). Most of the functions are controlled by the CEM. Control Modules, LS CAN The transfer speed on the LS CAN is 125 Kbps. The terminal resistors (120 ohm) are located in the SRS and the DIM.

Where is the diagnostic function in a Volvo S40?

The diagnostic function is in the CAN control module which also stores all the diagnostic trouble codes. Communication on the LIN bus is serial by conventional cable and at a transfer speed of about 10 kbps. The network in the S40 contains a total of 10 LIN buses and covers up to 22 control modules at the time of introduction.