How do you fix a motion sensor light stays on?

Reset your Motion Detector – To reset your motion light, unplug it from its power source for a full 10 seconds. Plug it back in and allow it to come back on. This should reset your light and turn off the auto-on function.

How long does it take for security light to turn off?

Insert ignition key and turn to the “ON” position. Do not attempt to start the engine. Leave the key in the “ON” position for approximately 11 minutes. The security light will be steady on or flashing for the 11-minute period. Do not proceed to Step 2 until the security light turns off or stops

What to do when your PassLock security light goes out?

The Body Control Moudle should re-learn the security signal, and the “SECURITY” light should go out. When it does, Turn the ignition OFF for five (5) seconds, and then try to re-start the car. The “SECURITY” light should remain off this time, and the car should keep running. If not, don’t give up.

How to turn on security light without starting engine?

Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “ON” position without starting the engine. Security light should turn on and stay on. Turn key to the “OFF” position.

Why is the outside security light always on?

Find out what main circuit it is on, then turn that off for about 20 secondes or so, then turn it on again. It should come on for a short while (about a minute), then turn off again and go back to normal. EDIT: Like Penalty Kick said about 8 hours ago – Sorry….

What to do if a security light does not turn off during?

This is normally an easy fix. If a security light is not turning off the way it is supposed to, you can reset many systems by toggling the power switch “on” and “off”. This should reboot the motion sensor or the timer and you can readjust it to your liking.

How long does it take for a car security light to go out?

With the key still in the run position wait 10 minutes and the security light should blink and then go out. Turn the key off and wait 5 seconds. Repeat these steps for a total for 3, 10 minute cycles.

Why does my outdoor security light keep coming on?

These dictate how long the light will stay on after being activated. Most models have durations that span from 1 minute to over a half hour. If it seems like your outdoor security lights are constantly on, it could just be that it’s activating frequently (due to high sensitivity levels) and then staying on for a very long time.

How to reset a motion light that stays on all the time?

Check the time switch to confirm it isn’t set in “Test” mode. If set in “Test” mode, move the switch to a pre-determined time setting. The “Test” mode could cause the light to come on and remain on. Reset the light to make sure it isn’t set to manual operation. Turn off the light switch that operates the motion light.