How do I reprogram my Weiser Smart Lock?

How do I reprogram my Weiser Smart Lock?

Press and HOLD Program button until keypad flashes green (about 5 seconds). Enter new mastercode. Press Lock button once. Re-enter mastercode.

How do I change the code on my Weiser keypad lock?

Manually put the bolt in the extended (lock) position. Press the PROGRAM button once, enter your new 4 – 8 digit code and then press the LOCK button. 2. Press the PROGRAM button twice, enter the same or a new code and then press the LOCK button once.

How do I reset my Weiser code?

A factory reset will delete all codes associated with the lock. 3 Press the Program button once more. In 20 seconds, when the LED flashes green and you hear one beep, the lock has been reset. 4 Perform the door handing process again to teach the lock the orientation of the door and add user codes to your lock.

How do I remove the code from my Weiser Smart Lock?

Deleting User Codes

1. Press the program button.
2. Press the lock button.
3. Enter user code to delete.
4. Press lock button.
5. Re-enter user code to delete.
6. Press lock button.
7. If successful, the keypad will flash green once and you will hear 1 beep (if switch #3 is on).

How do I change the code on my electronic door lock?

First, open the door and lift off the lock’s interior cover. Press the Program button once and you should hear your unit beep five times and see its checkmark icon at the keypad’s bottom left flash five times. Press the checkmark once and then enter the master code.

How do I reprogram my Weiser keypad?

Note: Programming instructions can also be found on interior of lock.

1. a. Press the program button on the interior unit once.
2. b. Enter in 4 to 8 digit code onto the keypad.
3. c. Press the “LOCK” button to save code.
4. d.
5. a. Press the program button on the interior unit twice.
6. b.
7. c.
8. d.

What is Weiser master code?

The lock is programmed with the default mastercode 0-0-0-0. Replace this with a code of your own. The mastercode must be 4-10 digits. Keep door open and unlocked during programming.

How to add user code to Weiser SmartCode 10?

If pairing is still unsuccessful, consult the Programming and Troubleshooting Guide on the SmartCode 10 Touchscreen page of online at www.weiserlock.com. Add user codes It is recommended that you Make sure the door is Press checkmark Enter user code.

How to enter master code in Weiser Lock?

1. Keep door open. Press the Program button once. The keypad will fl ash green and you will hear three beeps. 2. Press Lock button once. 3. Enter Mastercode. 4. Press Lock button once. 5. Press “9” six times. 6. Press Lock button once. Procedure continued on next page 5 / 15 62810 / 01 USA: 1-800-677-5625 Canada: 1-800-501-9471 www.weiserlock.com

How do you reset a Weiser door lock?

Press and HOLD the Program button while reinserting the battery pack. Keep holding the button for 30 seconds until the lock beeps and the status LED ˜ashes red. status LED Press the Program button once more. In 20 seconds, when the LED ˜ashes green and you hear one beep, the lock has been reset. Perform the door handing process again.

How does the SmartCode work on mo-tor?

● In thesteps below, the SmartCode mechanism automatically determines the “door handing” and sets the proper direction for mo- tor to rotate. The system will drive the bolt several times during this process. a.