Does a 2002 Dodge Dakota have a voltage regulator?
Does a 2002 Dodge Dakota have a voltage regulator?
The alternator’s current output is controlled by your Dodge Dakota’s fuel injection computer (PCM -Powertrain Control Module). This is done by the Electronic Voltage Regulator (EVR) circuit inside the PCM. When a problem occurs with the charging system, the PCM will set an alternator trouble code.
What did the check gauge light come on on my Dodge Ram?
My 2004 5.7 Hemi Today the check gage light came on and the oil PSI fell down to zero when I turned a cornner. It was one quart low so I added one quart of oil and it seems fine now. Just sharing.
What are the warning lights on a Dodge?
What follows is easily the most complete list available of symbols and warnings that may appear in and on your car’s dashboard or instrument cluster. The following are warning lights and indicators found in vehicles built by Dodge. Click a link to learn more about each one.
What is the diagnostic code for a Dodge check engine light?
Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s). Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Dodge diagnostic trouble codes. Manufacturer Specific Codes P0138HO2S12 High Voltage – Related Information
What to do when your car gauges are not working?
The fuse should have power on both sides when the ignition key is turned to the on position. You can check this with an inexpensive test light or multimeter, or take your car to a mechanic if you don’t have the right tools or aren’t comfortable digging into a diagnostic like this.
Where is the check gauge on a Dakota Durango?
In case anyone reads this in the future, when you start your Dakota/Durango and the Vehicle Starts, Voltage Guage goes up to 10-11 Volts then drops down to 0 and “check gauges” light comes on, your first check is the Big Fuse located in the ECM (engine Control Module). Usually 120-140 or 160 depending on your alternator.
How to check guages light battery with Dakota forumz?
Click to expand… and engine oil pressure. If an extreme condition is indicated, the lamp will be illuminated. This is done as reminder to check the three gauges. The signal to activate the lamp is sent via the CCD bus circuits. below. 1. The large one is the battery (output) terminal and it goes directly to the battery
My 2004 5.7 Hemi Today the check gage light came on and the oil PSI fell down to zero when I turned a cornner. It was one quart low so I added one quart of oil and it seems fine now. Just sharing.
What follows is easily the most complete list available of symbols and warnings that may appear in and on your car’s dashboard or instrument cluster. The following are warning lights and indicators found in vehicles built by Dodge. Click a link to learn more about each one.
