Does a 2000 Ford Ranger have torsion bars?

The 2001-2005 Ford Ranger Edge and the 2006-2009 Ford Ranger Sport came with a torsion bar front suspension. Also, there was a 2000 Ford Ranger Trailhead 2WD that came with the torsion bar front suspension.

How do you release a torsion bar?

Remove the torsion-bar adjusting bolt using the air impact wrench and impact sockets. Pull the torsion bar towards the tailgate of the truck to free it from the lower control arm. Then pull the torsion bar towards the lower control arm but underneath it to free the bar from the torsion-bar key in the cross-member.

How big are the torsion bars on a Ford Ranger?

In 2008, ford clocked the keys a few degrees to lower the Ranger and give it better handling and MPG characteristics. If you get a set of factory torsion bar keys from a 2007 or older 4×4 Ranger, and install them in a 2008 or newer Ranger, it will lift that Ranger 1.75-2.00 inches in the front.

What kind of suspension does a Ford Ranger have?

2008-2011 Ford Ranger 4×4 Torsion Suspension Versus 1998-2007 Torsion Bar Suspension: In 2008, ford clocked the keys a few degrees to lower the Ranger and give it better handling and MPG characteristics.

Which is the front and rear torsion bar?

You might see both front and rear torsion bars beneath your vehicle. The front torsion bar is closest to the engine, and it’s what you’ll be adjusting. The front torsion bar has a small key in the center. This key helps the bar stay in place.

How do you adjust the tire on a torsion bar?

Search for the adjustment bolts on both sides of the torsion bar. Look closely to find a set of bolts on both sides. Use the bolt on the left to adjust the left tire, and tweak the rightmost bolt to make changes to the right tire.

How do you adjust the torsion bar on a Ford Ranger?

Fasten a 13mm socket to the bolt, stick your breaker bar on the end of the socket wrench.. and begin to tighten it (Righty tighty, lefty loosey) (Or Clockwise for Tightening, Counter for Loosening). A good sized breaker bar will give you PLENTY of leverage, Adjust both sides EXACTLY the same, and a small amount at a time..

What’s the best way to adjust torsion bars?

A good sized breaker bar will give you PLENTY of leverage, Adjust both sides EXACTLY the same, and a small amount at a time.. Go roughly 1/2 a turn on each side, then got up and measured the gap in the tire to the wheel well every time.

When to upgrade front shocks on Ford Ranger?

It is HIGHLY RECOMMENDED to upgrade to extended length front shocks during the install process. The reason being that when the new torsion keys are installed the stock shocks have to be extended unnaturally to accommodate the 2.50 inch front lift.

Does a 2000 Ford Ranger have torsion bars?