Do you have to support engine when removing transmission?
Do you have to support engine when removing transmission?
Note: When lowering the transmission in order to give you the added work space needed to remove the top bell housing bolts, the weight of the transmission still needs to be supported by the jack. If the jack is lowered completely, the engine will tilt severely on its mounts, possible weakening or breaking the mounts.
When did Corvette go to rear transmission?
1997
First Corvette with a transaxle: To better balance and improve the handling of the fifth-generation Corvette, which debuted in 1997, Chevy engineers moved from a traditional transmission location, which is bolted to the engine, to a transaxle design that moves the gearbox to the rear of the car.
When to remove the engine from a corvette?
This procedure applys to 1953 to 1982 non computerized cars with a standard transmission. I found the service manual only gives a cursory view of the procedure. The manual states to remove the engine / transmission as a unit.
What to do if your transmission is loose on a C3 Corvette?
BorgWarner 4-speeds If you’re having difficulty shifting the 4-speed in your C3, first check to determine whether your engine and transmission mounts are loose. Raise the car safely in the air and set it on safety stands. Then place a floor jack under the transmission while putting a piece of scrap wood between the jack pad and the transmission.
Where is the transmission on a 1973 Corvette?
The Muncie M20 wide-ratio 4-speed has been installed behind a 190-hp, 350-ci engine in this 1973 Corvette. (Note the shifter, shifting levers, and the reverse lockout cable.) The transmission is attached to the frame with two bolts on a bracket that bolts to the frame and to the transmission extension. The exhaust is also mounted onto this bracket.
When was the last year a corvette had a 4 speed transmission?
The last year the optional L82 engine was available with a 4-speed was 1979. During its last year of production in 1980 the L82 engine was only available with an automatic transmission. BorgWarner transmissions for Corvettes have a 26-spline input shaft and a 32-spline TH400 output shaft.
This procedure applys to 1953 to 1982 non computerized cars with a standard transmission. I found the service manual only gives a cursory view of the procedure. The manual states to remove the engine / transmission as a unit.
What was the transmission on a 1969 Corvette?
The 3-speed manual was also included in the base price of a 1969 Corvette, but was replaced with a wide-ratio 4-speed in 1970. At the end of C3 production in 1982 only a 4-speed automatic transmission was available.
BorgWarner 4-speeds If you’re having difficulty shifting the 4-speed in your C3, first check to determine whether your engine and transmission mounts are loose. Raise the car safely in the air and set it on safety stands. Then place a floor jack under the transmission while putting a piece of scrap wood between the jack pad and the transmission.
How to remove the body of a corvette?
1. Battery – Disconnect only 2. Steering Column – Disconnect and remove 3. Master Cylinder – Disconnect lines only 4. Clutch Rod pedal – Disconnect wire clip only 5. Back up light plug – Disconnect only 6. Acceleration rod and ground straps – Disconnect only 7. Oil pressure line, big and small block – Disconnect only 8. Engine Wires:
