Are there any problems with the Oliver mechanic?
Are there any problems with the Oliver mechanic?
The hydraulics are working now with one problem. The right hand remote will not hold in a set position, it bleeds down very fast when on a grading blade etc.. The left side does just fine. I found a bad spot in the cover gasket, a snap ring that had jumped out of place, and one of the 6 tubes between the cover and housing was missing all together.
What’s the IP on an Oliver 1750 diesel?
Re(1): Oliver 1750 IP: 75.104.183.109 Posted on March 30, 2010 at 06:41:27 AM by Larry Harsin There might be some O rings that are bad on the connectors on the lid or it could be the gasket. Larry 880 Diesel IP: 98.28.119.37 Posted on March 27, 2010 at 07:15:02 PM by Ryan
What kind of problem does an Oliver 1750 have?
Larry, I have an oliver 1750 and the pto keeps turning all the time. I always have to shut the tractor off when hooking up an implement shaft. Of course then the implement runs when it does not have a load. I also have an 1850 with the same problem but not quite as bad.
What causes drag on a Larry Oliver tractor?
That’s just the way these tractors are because oil is pumped into the clutches and causes the drag. After the tractor is warmed up, it is not quite as bad. Larry Oliver Super 55 IP: 71.227.216.191 Posted on March 28, 2010 at 09:58:08 PM by gary
Larry, I have an oliver 1750 and the pto keeps turning all the time. I always have to shut the tractor off when hooking up an implement shaft. Of course then the implement runs when it does not have a load. I also have an 1850 with the same problem but not quite as bad.
The hydraulics are working now with one problem. The right hand remote will not hold in a set position, it bleeds down very fast when on a grading blade etc.. The left side does just fine. I found a bad spot in the cover gasket, a snap ring that had jumped out of place, and one of the 6 tubes between the cover and housing was missing all together.
What is the IP of the Oliver mechanic?
It doesn’t matter how hard you pull on the engagement lever the shaft will not stop turning. Re(1): PTO drag IP: 75.104.183.109 Posted on April 1, 2010 at 06:07:09 AM by Larry Harsin
