Why is my Peugeot 206 clutch not working?

Why is my Peugeot 206 clutch not working?

Win! REPXPERT Alistair Mason inspected a 2005 1.1L petrol Peugeot 206, which had covered more than 75,000 miles. It was difficult to get the vehicle into gear, as the clutch was not fully disengaging and there was a ‘scraping’ noise emanating from the bell housing area, so a gearbox removal was advised and authorised.

How many miles has a Peugeot 206 covered?

REPXPERT Alistair Mason inspected a 2005 1.1L petrol Peugeot 206, which had covered more than 75,000 miles. It was difficult to get the vehicle into gear, as the clutch was not fully disengaging and there was a ‘scraping’ noise emanating from the bell housing area, so a gearbox removal was advised and authorised.

How to reset the auto adjuster on the clutch cable?

If you can pull the clutch end taut and anchor it, do so, otherwise maintain the load. 4, Slide the sleeving from the pedal end towards the clutch end until it stops. This will release the ratcheting system. Now push (NOT pull) the sleeving back towards the pedal end.

How do you remove a gearbox from a Peugeot 206?

A gearbox removal should be a straightforward task for an independent technician. With the vehicle placed on the ramp, open the bonnet and remove the air filter/box assembly, the battery and carrier, which gives good access to the top of the gearbox and bell housing area (see below).

When to change the clutch on a Peugeot 206?

This is part 1 of replacing the clutch on a typical Peugeot 206. This example is a late 2004 year, 1.1 litre 8 valve petrol engine with the five speed MA5 transmission. The car has done (at time of clutch change) 88,501 miles. Stop start urban crawl has probably ended the clutch because it should have lasted a lot longer than 88k miles.

What to do when the clutch cable won’t pull out?

Whenever I have an auto adjust cable on a citroen or peugeot that won’t pull out I normally lever the clutch arm back with a long bar and hook the cable on. Push the pedal and it should release once the pedal returns. Re: Resetting auto adjuster on clutch cable.

How do you reset the clutch cable on a car?

Resetting the cable with the part number GCC3106 should be carried out from the pedal side. Firstly, push the inner cable into the outer cable, again all the way to the stop, until the protruding plastic sleeve engages audibly. Then the adjustment mechanism can be pushed together through the outer cable and therefore reset.

Is there a problem with the clutch pedal on a Citroen?

Simon Hughes talks about a common failure of the clutch pedal amongst early 2000 model Peugeots and Citroens, and has some advice on how to easily fix the problem without having to payout expensive callout and replacement charges. Loading…