What should the dwell be on a Datsun 1200 Club?
What should the dwell be on a Datsun 1200 Club?
Use a dwell meter if at all possible as it is much more accurate than the points gap, Set dwell 49 to 55 degrees. If the points are brand new, a feeler gauge can be used to set the gap to 0.020 inch. Incorrect Dwell can cause rough running, as does bad points. For example, it might only run at high idle, and not very smooth at that.
What kind of distributor does a Datsun Hitachi use?
Uses standard Hitachi 22100-A3502 distributor cap, rotor, etc. Perfect replacement for worn-out Hitachi distributors from Datsun/Nissan L16, L18 and L20B 4-cylinder engines. The HS-HIT4 distributor is compatible with these standard Hitachi parts:
What kind of nozzles did a 1972 Datsun 240 use?
– the 1970-71 240 used “N27” needles and related nozzles. – the 1972 manual trans car used N54 needles, the 1972 automatic used N58, both with the same 1972 nozzles. – the 1973 nozzles/needles were emissions designs, not recommended for performance.
Which is the direction of rotation on a Datsun?
The direction of rotation (Yellow arrow) is always opposite the direction that vacuum advance points (green arrow) — for all engines, not just Datsuns. Next, following the direction of rotation (Yellow arrow), count off 1-3-4-2. Here is the 1974-up distributor:
What are the ignition points on a 1970 Datsun 240Z?
New distributor ignition points for Datsun 240Z, 1970-1973 and 68-73 510. High quality replacements. New ignition condensor for 1970 1971 1972 1973 Datsun 240Z with Dual point dist, automatic cars. Condensor on… New OEM genuine Nissan distributor plate for Datsun 240Z, 1970- 7/73.
Use a dwell meter if at all possible as it is much more accurate than the points gap, Set dwell 49 to 55 degrees. If the points are brand new, a feeler gauge can be used to set the gap to 0.020 inch. Incorrect Dwell can cause rough running, as does bad points. For example, it might only run at high idle, and not very smooth at that.
What kind of transmission does a Datsun 240Z have?
New condensor for Datsun 240Z, 1970-73 with manual transmission and single point distributor. New distributor rotor for 1970-73 Datsun 240Z and 68-73 510. Reproduction original look key blank for your Datsun 240Z, 260Z and 280Z, 1970-78.
Uses standard Hitachi 22100-A3502 distributor cap, rotor, etc. Perfect replacement for worn-out Hitachi distributors from Datsun/Nissan L16, L18 and L20B 4-cylinder engines. The HS-HIT4 distributor is compatible with these standard Hitachi parts:
