How does the ignition system work on a Willys Jeep?
How does the ignition system work on a Willys Jeep?
The Willys Jeep Ignition System The method by which an internal combustion engine is powered comes from burning a fuel and air mixture in the engine cylinders under compression. The gases are ignited by a spark made to jump a small gap in the spark plug within each combustion chamber. The ignition system provides this spark.
How to set timing gun light on Willys Jeep?
15. Point the timing gun light down to the area next to the start and Remove the timing cover plate, and the blink of the light should match the IGN (compression stroke) setting on the flywheel as it spins around. If it is after or before the light, then you have to adjust the distributor to line it up.
How to adjust the distributor on a Willys Jeep?
Adjusting the Distributor : Slightly loosen the distributor bolt into the block so the distributor can turn. While the engine is running, point the timing light to the flywheel. If you turn the distributor clockwise you are advancing the timing, thus making the markings move forward or up.
What causes weak spark in Willys ignition system?
If the condenser is leaky a weak spark will occur. Check the condenser lead for broken wires or frayed insulation. Clean and tighten the connections on the terminal posts. Make sure the condenser is mounting firmly on the distributor for a good ground connection.
The Willys Jeep Ignition System The method by which an internal combustion engine is powered comes from burning a fuel and air mixture in the engine cylinders under compression. The gases are ignited by a spark made to jump a small gap in the spark plug within each combustion chamber. The ignition system provides this spark.
15. Point the timing gun light down to the area next to the start and Remove the timing cover plate, and the blink of the light should match the IGN (compression stroke) setting on the flywheel as it spins around. If it is after or before the light, then you have to adjust the distributor to line it up.
Adjusting the Distributor : Slightly loosen the distributor bolt into the block so the distributor can turn. While the engine is running, point the timing light to the flywheel. If you turn the distributor clockwise you are advancing the timing, thus making the markings move forward or up.
When to replace spark plugs on a Willys Jeep?
Your spark plugs should have residue from the gas mixture igniting. You should not have signs of water, coolant, excessive oil. Also, if the plugs look worn down, they should be replaced. With unleaded fuels of today, there are much less deposits left on the sparkplugs then years ago. 12. Installing new spark plugs is easy.
