What kind of brake problem does Chevy Silverado have?

I have a 2003 Silverado 1500 4×4, I have been experiencing a front brake rattle when drive rough spots in the road with my foot off the brake, when I apply slight pedal pressure the rattle is gone. I have taken to the dealer multiple time with no results, they say from temp changes to lubrications of the slides.

How do you know if your Chevy has a brake problem?

You will find the booster between the master cylinder and the firewall in your engine compartment. A check valve that is faulty can also let vacuum bleed out. You can diagnose this by starting your Chevy in order to build vacuum, and then turning it off for four or five minutes. Then you should try the brakes.

How to bleed the rear brakes on a C / K 1500?

Once you are certain of a firm pedal, drive the vehicle at more than three miles per hour so the controller can automatically reset the system. Stop the vehicle afterward and bleed the rear brakes. Scan Tool Attach a pressure bleeder to the master cylinder reservoir and turn the ignition key to the On position.

What causes the brake lines to bleed on a Chevy?

Bleed the brake lines as recommended by Chevy to fix this. You could also have a ballooning brake hose when the brakes are applied. Check your brake hoses for anomalies. Excessive Brake Travel: If the brake linings are worn, the drum brakes are misadjusted or the brake lines have air in them, you will have this issue.

Why are my brake pads sticking on my Chevy Silverado?

There are notches in your Silverado’s brake pads that let them slide back and forth from the rotor as the brakes are pressed. If something gets into these slides, the pads may not disengage from the rotor all the way. This problem is often caused by bad shims or junk getting in the way.

What causes a soft brake pedal on a Chevy?

Soft or Spongy Brake Pedal: Too much air in the system due to improper bleeding is usually the cause of this problem. However, it can also be due to fluid loss or a low fluid level. Bleed the brake lines as recommended by Chevy to fix this. You could also have a ballooning brake hose when the brakes are applied.

What causes brake fluid to go down in a Chevy?

Even with proper maintenance, you may find yourself with an unexpected brake problem — here are some of the most common examples. Low Brake Fluid: Your Chevy may develop a leak in the system that will result in the fluid level going down.

What does it mean when your front brake is not working?

Brake Pull: Uneven braking means that you have one front brake on your Chevy that is not operating properly. Your brakes pull to the good side. This can be due to oil, grease or fluid on a pad, a caliper that is stuck, brake line blockage, or wheel bearings that are loose.

Are there soft brakes on a 2002 Chevy Silverado?

Soft brakes on a 2002 Chevrolet Silverado, 2WD, 104K – Maintenance/Repairs – Car Talk Community I have a 2002 Chevy Silverado I just bought used with 104K miles. Brakes are extremely soft…meaning I have to push pedal in a long ways before pressure. I checked front and rear pads and they all look brand new. Any…

Can a brake caliper stick on a Chevy Silverado?

Your Chevy Silverado’s braking system is the most important safety feature on the vehicle. If it does not work properly, it can put you in a situation where you can be injured or killed. There are quite a few different situations that can cause a caliper to stick.

What kind of accident can a Chevy Silverado have?

I just had an accident resulting from a brake failure with my 2000 Chevy Silverado 1500 truck. I was making a left hand turn into a parking stall (was going about 5 mph) and when I pressed on the brake pedal my vehicle did not stop. My truck hopped the curb and went down a slight hill and rammed into a retaining wall.

When did the GM truck brake problem start?

Owners were to be notified starting Sept. 6. NHTSA, the government’s road safety agency, began investigating the problem last year after getting 111 complaints from owners of poor brake performance. At the time the agency had nine reports of crashes that had caused two injuries.

Is it safe to drive a 2003 Chevy Silverado?

I own a 2003 Silverado that has intermittent brake failure problems . The dealer has repaired this time and time again but the problem persists . The dealer and now GM say that this is a normal function for this vehicle , but now the brake pedal goes to the floor and although they are telling me it is safe to drive I am refusing .

Where are the parking brake shoes on a Chevy Silverado?

Yes. The rear rotors have the barking brake on the inside or back side of your rotors. The parking brake shoes operate similar to the old drums whereas they push out on the internal surface of the drum which is actually the inside component of your rotors. here’s a picture of a slotted rear rotor where you can see the internal drum surface.

Why do I have a brake problem on my 2004 Silverado?

When at a stop, I can feel the pedal slowly sinking. Pumping the pedal sounds like either ai in the lines or a bad booster. Bleed the system correctly starting at the bypass valve then working from the next farthest out caliper (rt rear) next closest and so on until you’ve bled all the calipers.

Where was the 2004 Chevy Silverado 2500HD last serviced?

1st owner drove an estimated 13,621 miles/year • 2nd owner drove an estimated 10,140 miles/year • 3rd owner drove an estimated 8,888 miles/year. Last serviced at 178,455 miles in Sevierville, TN on 03/26/19 • Vehicle serviced. Mileage: 194,602 miles Body Type: Pickup Color: Silver Engine: 8 Cyl 6.0 L No accident or damage reported to CARFAX.

What kind of brakes does a Silverado 1500 have?

2006 1500 2 WHEEL DRIVE 4.3L, DRUMS ON BACK, 66325 MILES. The truck has been a reliable work horse up until I replaced the front brake pads, the disk look new at the time, in the 15 mile ride home the front rotor get hot (blue instead of gray) the brakes smell hot and the wheel near the hub will burn you.

Why is the parking brake on my 2003 Chevy Silverado not working?

It’s not us. Brake line failure due to excessive corrosion. Was able to apply emergency brake and come to a safe stop. The contact owns a 2003 chervrolet Silverado. The contact stated that the parking brake failed. The vehicle was taken to the dealer and it was determined that the vehicle needed to have the lining replaced on the vehicle.

Why does my abs not work on my Silverado?

Here is how to fix spongy brake pedal feel on a 1988 to 1998 Chevrolet Silverado truck. If your truck has an antilock brake module in it, and that ABS module has air bubbles in it, you will have spongy squishy brake pedal feel even if your ABS system isn’t working. In my case, the brakes were so bad that the brake warning light came on.

Why does my Chevy Silverado shake when I brake?

The Silverado will come to a stop noise free. If the brake pads are worn past their useful life, or if they are dirty, they will no longer be able to make the quality contact with your steering wheel. At this point, you’ll feel your steering wheel shake as the brakes are pressed down.

Why does my Silverado not have anti lock brakes?

This happens on my 2001 Silverado. It is supposedly caused by rust where the sensor wire harness connects to the front rotors, as the rust separates the sensor just enough so it gives a false reading and activates the anti-lock brakes.

What was the problem with my Chevy Silverado?

The first mechanic totally hosed the whole thing, had my truck for months (seriously!) and all he did was run new lines to the front of the truck. Problem was, instead of using the proper lines (everything in the kit was pre=bent and marked), he cut up the long lines that should have run to the back of the truck to do the fronts.

How can I tell if My Chevy Silverado is the same as my Chevy?

Go to the junkyard, find a truck of same make and model as yours, look at the master cylinder and follow the steel lines until you are reasonably sure which one goes to which wheel. Then, pop your hood and make sure yours is the same.

How can I tell if my Silverado has anti lock brakes?

Sounds like your anti lock is kicking in. You can check with a multimeter to ensure you have the right amount of space between the sensor and wheel bearing but I just put one spacer on the sensor, bolt it back to the hib and spin my hub and liaten and feel for scraping. If u dont then put your caliper back on and test your brakes.

Why is my brake light not working on my Chevy Silverado?

Chances are the cause of the defective light or brake lights circuit on your Chevy Silverado is a simple problem. Moreover, you can blame most of these problems on little or no maintenance, according to James E. Duffy in “Modern Automotive Technology.”

What kind of brake problem does Chevy Silverado have?