What was the rear window on a Porsche 912?
What was the rear window on a Porsche 912?
SIC-545-101-20 Rear Window, Clear Without Defroster Heating Elements. Correct for Early 911 912 90154510120 SIC54510120 901-565-556-40 Bright aluminum trim, right rear window. Fits 1968-1973 (Targa). 90156555640
What are the parts of a Porsche 911?
Everything from Porsche windows and glass through to 911 badges, seals and all those small pieces of Porsche trim that finish off a Porsche restoration perfectly!
What kind of glass does a Porsche 911 have?
The 911 glass, rubber seals and window section is broken down into the several sections that follow the specific type of 911 you are working on. T52-BON Stoddard Bone Assembly and Trim or Weatherstripping Tool. Exclusively From Stoddard Authentic Parts Diagram # 1 SIC-541-912-20 Front Windshield Trim, Right, Bright Aluminum.
Why does my Porsche 911 have a vacuum problem?
Crankcase vacuum exceeds the normal range in the engine under heavy acceleration and sucks in air damaging the rear main seal. This is commonly seen on Audi engines as well.
Why does my Porsche 911 have rear window glass?
The length of the glass may actually magnify stresses and forces placed on the windshield. The side windows and rear glass are less susceptible to cracking. However, the rear window needs special consideration because of the defroster wire that is running through the seal.
Why is there a problem with my Porsche 911?
If all of these steps fail to pinpoint the problem, then you probably made a mistake somewhere along the line, or there might be a short circuit somewhere in the switch or the wiring of the car. Only painstaking testing using a continuity tester will be able to locate such a problem.
When to replace ignition switch in Porsche 911?
The car can refuse to start some of the time, the key may not turn too easily in the ignition, or strange electrical problems like the headlamps flickering on and off may appear. Either way, the correct solution is to replace all or part of the ignition switch.
How to troubleshoot a Porsche 911 blower motor problem?
In the case of the rear blower motor, the switch is connected to the red handles on the floor of the car. Check the switch with a continuity tester to make sure that it is working properly. Finally, if all the other tests fail to locate the problem, the wiring may be at fault.
