How do you change the ignition switch on a 1974 Corvette?
How do you change the ignition switch on a 1974 Corvette?
Remove the rubber sleeve bumper from the steering shaft. Using an appropriate tool, remove the plastic retainer. Using a spring compressor, depress the upper steering shaft spring and remove the C-ring. Release the steering shaft lockplate, the horn contact carrier, and the upper steering shaft preload spring.
How do you replace an ignition switch on a car?
Installing a Replacement Squeeze the release pin on the ignition switch so it’s flush with the side. The same release pin that stopped the switch from coming out now needs to be pressed in so you can slide the switch into place inside the ignition module. Slide the ignition switch into its hole.
Why is my ignition switch not turning off?
Replaced ignition lock but the ignition switch rod will not let lock come back to the off position. had same problem before I changed lock. It’s usually the rotating part of the gear shifter that’s located on the steering column, being out of place, that will cause the ignition switch and rod not to be able to turn off all the way.
Where is the VTD located on an ignition switch?
Vehicles with steering column mounted ignition switches have the exciter integral with the theft deterrent control module (VTD) which is located within the steering column. Replaced ignition lock but the ignition switch rod will not let lock come back to the off position. had same problem before I changed lock.
Installing a Replacement Squeeze the release pin on the ignition switch so it’s flush with the side. The same release pin that stopped the switch from coming out now needs to be pressed in so you can slide the switch into place inside the ignition module. Slide the ignition switch into its hole.
What happens if you have a faulty ignition switch?
A faulty ignition switch in your vehicle can cause several problems ranging from your car stalling and all lights going dark to the radio not working unless the key is wiggled from side to side.
What to do if your key is stuck in the ignition switch?
The key may be stuck in the ignition switch, but that shouldn’t stop you from turning it. If you don’t have a key, you will need to force the module to turn using a flathead screwdriver. Press the release pin inside the hole on the ignition module with a screwdriver.
What’s the Accessory position on an ignition switch?
Insert the key and turn it to the “accessory” position. The ignition switch needs to be set to the accessory position before you can release it from the ignition module. The “accessory” position is before the starter is engaged, and would normally let you run the vehicle’s electronics without the engine running (when the battery is connected).
