How do I adjust the ls1 throttle cable?
How do I adjust the ls1 throttle cable?
There is a cable adjuster half way down the cable. Lift up the tab, remove the slack & push the tab back down. Takes about 5 seconds. With the BBK throttle body you should have also recieved a new cable mounting plate which offsets the cruise control cable to make it work.
How do you adjust the throttle valve cable?
Tip: Consult the owner’s manual for any specifications for your car’s make and model. Adjust the cable by a small increment then have your helper press the gas pedal all the way down and check the cable at WOT. Lengthening the cable will allow the vehicle to shift earlier and the shift will be softer.
How do you disconnect the throttle on a Honda Accord?
The cable must be adjusted so it is pulled fully out at wide-open throttle. To make sure disconnect the cable, hold the throttle wide open with your left hand, pull the cable fully out with your right hand and see if the cable end lines up with the button on the throttle lever.
How do you remove a kickdown cable adjuster?
Leave the kickdown mounting bracket on the kickdown cable adjuster. Remove the inner wire from the cable housing, and remove the transmission cable end assembly from the inner wire. Step 2:Remove the lower left tail housing bolt from the transmission.
How to remove kickdown cable on Chrysler 727?
Step 1: Remove the cable end stop, kickdown throttle body fitting, and kickdown cable adjuster from the end of the inner wire. If you have the braided stainless steel housing, make sure you DO NOT remove the ferrule from the cable housing. Leave the kickdown mounting bracket on the kickdown cable adjuster.
The final step is to adjust the throttle valve cable. The cable must be adjusted so it is pulled fully out at wide-open throttle. To make sure disconnect the cable, hold the throttle wide open with your left hand, pull the cable fully out with your right hand and see if the cable end lines up with the button on the throttle lever.
The cable must be adjusted so it is pulled fully out at wide-open throttle. To make sure disconnect the cable, hold the throttle wide open with your left hand, pull the cable fully out with your right hand and see if the cable end lines up with the button on the throttle lever.
Leave the kickdown mounting bracket on the kickdown cable adjuster. Remove the inner wire from the cable housing, and remove the transmission cable end assembly from the inner wire. Step 2:Remove the lower left tail housing bolt from the transmission.
How to adjust throttle cable on 700R4 TV?
700R4 – 200-4R Throttle Valve Cable Instructions-700R4 TV Adjustment #1. The button that the cable hooks to at the carburetor or throttle body must have approximately 1 and 3/32-inch radius… #2. Looking at the throttle shaft lever from the left side at idle position, approximately 33% of the
