What is accessory drive belt?
What is accessory drive belt?
Accessory drive belts are used to drive all the accessories that run off the front of the engine. The drive belt is responsible for using the engine’s revolutions to drive the power steering pump, a/c compressor, alternator, water pump, and other belt driven accessories.
How do you take a drive belt out of a car?
While holding the tensioner back with one hand, use your other hand to slip the belt off of one of the accessory pulleys (choose the pulley that’s easiest to reach). Feed the belt out and away from the remaining pulleys, then remove the belt from the vehicle.
How do you remove a belt from an auto tensioner?
Hold the tension from the belt, and slip the belt off the auto tensioner pulley to remove the belt and pulley system. Slowly release the tension to avoid damage or injury, and then remove the tool from the belt auto tensioner.
How do you remove an old serpentine belt?
To remove an old serpentine belt, or to tighten up a new one, the tensioner bolt on the tensioner pulley is turned until proper tightness is achieved. Please see your repair manual for the recommended tension on your vehicle’s engine.
What’s the best way to loosen a pulley belt?
Try both directions, which will require you to flip the selector on the wrench to the opposite direction (so you can loosen or tighten). The tensioner will move only in one direction, and when moved will release its grip on the belt. Make sure you study how the original belt wraps around the various pulleys.
How do you remove a pulley belt from a car?
With the tension relieved from the belt, pull it off of the pulley that has been placing tension on it, then remove it from the around the rest of the pulleys on the engine. If the belt is severely damaged, be sure to remove any parts that may have come off of it as well. Compare the new belt to the old one.
Hold the tension from the belt, and slip the belt off the auto tensioner pulley to remove the belt and pulley system. Slowly release the tension to avoid damage or injury, and then remove the tool from the belt auto tensioner.
How do you remove the belt on a Chevy Silverado?
Belt noise begins when the spring weakens or the pulley bearing begins to wobble. The engine crank pulley drives both belts. To remove the A/C belt, the accessory belt must first be loosened and slipped off the engine crank pulley.
What’s the best way to remove a serpentine belt?
Its pulley is usually smooth while the other pulleys are grooved. The way to remove tension will be to pivot the tensioner using a tool (1) on the nut of the tensioner pulley, or (2) a special tool-lug outcropping from the tensioner or (3) in a square opening in the bracket of the tensioner pulley, cover or cap that protects the spring.
