How to replace a fuel pump in a Chrysler Sebring?
How to replace a fuel pump in a Chrysler Sebring?
Unlock the retainer for the fuel pump electrical connector and push down on the retainer to disconnect it from the fuel pump. You can now lower the fuel tank and mark the fuel pump location. Remove the fuel pump lock ring with a brass punch and hammer and remove the fuel pump and O-ring seal. Discard the old O-ring seal.
What kind of engine does a Chrysler Sebring have?
Models made from 2001 to 2006 can have a 2.4 L EDZ or 2.7 L EER engine. Models made after 2006 have choices that include a 2.0 L GEMA, 2.0 L TDI, 2.4 L GEMA, 2.7 L EER or 3.5 L EGJ engine. Prepare your vehicle for fuel pump servicing. Release the fuel system pressure and disconnect the negative battery cable with a socket wrench.
Where is the ASD relay on a Chrysler Sebring?
The automatic shut down (ASD) relay turns off voltage to the primary coil on the distributor, power to the fuel injectors and turns the fuel pump off when you turn off your Chrysler Sebring so that it doesn’t sputter. The ASD relay is located in different places, depending on your model-year Chrysler,…
Where is the power harness on a Sebring?
Unplug the wiring harness connector on the power module, which is usually located near the front of the vehicle on the driver’s side. Use your fingers to manipulate the tangs on the plugs. Some vehicles may have a screw holding the plugs, in addition to the tangs.
Unlock the retainer for the fuel pump electrical connector and push down on the retainer to disconnect it from the fuel pump. You can now lower the fuel tank and mark the fuel pump location. Remove the fuel pump lock ring with a brass punch and hammer and remove the fuel pump and O-ring seal. Discard the old O-ring seal.
Models made from 2001 to 2006 can have a 2.4 L EDZ or 2.7 L EER engine. Models made after 2006 have choices that include a 2.0 L GEMA, 2.0 L TDI, 2.4 L GEMA, 2.7 L EER or 3.5 L EGJ engine. Prepare your vehicle for fuel pump servicing. Release the fuel system pressure and disconnect the negative battery cable with a socket wrench.
How do you replace fuel pump lock ring?
Remove the fuel pump lock ring with a brass punch and hammer and remove the fuel pump and O-ring seal. Discard the old O-ring seal. Install the new fuel pump using the items included in the kit, especially the O-ring seal.
Remove the fuel pump lock ring with a brass punch and hammer and remove the fuel pump and O-ring seal. Discard the old O-ring seal. Install the new fuel pump using the items included in the kit, especially the O-ring seal.
How to change a broken fuel pump without dropping the gas tank?
TheCousinDan shows you how to change a broken fuel pump without dropping the gas tank. This time it’s done by actually cutting a hole in your car (don’t worry, it’s not as bad as it sounds). Music: NCS Def Kev
