Why is my PT Cruiser GT misfiring and bucking?
Why is my PT Cruiser GT misfiring and bucking?
Possible an oxygen sensor. Or cam shaft positioning sensor but if you change the cam shaft sensor make sure you also change the crank shaft positioning sensor or you will need to change your cam shaft sensor again in a year. Just wondering if the changing the cam shaft sensor helped to stop the misfiring and bucking.
Where is the upper sensor on a PT Cruiser?
The reason if fails again after 3 to 4 months isn’t related to it being aftermarket vs mopar auto parts. There are two sensors the measure the position of the camshaft and crankshaft (they are not the same thing). The upper sensor is the Camshaft Position Sensor and is located at the top of the engine beside the air intake box.
What should I do about my 2005 PT Cruiser GT?
I have PT Cruiser 2005 GT.. w/85k ..getting code P171, have replace TIP , MAP, both Oxygen sensors, fuel line, thermostat, spark plugs and wires. Ran BG44K also replace upper and lower intake manifold gaskets. took to dealer they not sure either .
When did I replace the clutch on my PT Cruiser?
I purchased a 03 Pt Cruiser with a manual transmission in July 10, Well in Oct 10 the Timing belt had to be replaced along with the water pump. 700.00. In Feb 11 the fuel purge sensor had to be replaces 200.00, Mar 11 the clutch and pressure plate 900.00.
Possible an oxygen sensor. Or cam shaft positioning sensor but if you change the cam shaft sensor make sure you also change the crank shaft positioning sensor or you will need to change your cam shaft sensor again in a year. Just wondering if the changing the cam shaft sensor helped to stop the misfiring and bucking.
I have PT Cruiser 2005 GT.. w/85k ..getting code P171, have replace TIP , MAP, both Oxygen sensors, fuel line, thermostat, spark plugs and wires. Ran BG44K also replace upper and lower intake manifold gaskets. took to dealer they not sure either .
The reason if fails again after 3 to 4 months isn’t related to it being aftermarket vs mopar auto parts. There are two sensors the measure the position of the camshaft and crankshaft (they are not the same thing). The upper sensor is the Camshaft Position Sensor and is located at the top of the engine beside the air intake box.
What kind of engine does PT Cruiser 2.4lt have?
2006 PT cruiser 2.4lt checked , had code for cyl 4 misfire found oil in spark plugs holes had good spark all cylinders replaced plugs wires and valve cover gasket with valve cover off found intake cam lobes on #4 cyl worn down replaced intake cam ran fine for 30 miles ]
What was the problem with my PT Cruiser GT?
MY 2007 PT non-turbo did the same thing at about 18K miles. It was the camshaft positioning sensor. It is a $65 part. I had it replaced under warranty. Knowing what it looks like and how easy it is to replace, I will replace it myself next time. It involved removing two screws and an electrical lead- no biggie.
What causes engine light to come on on PT Cruiser?
11 people found this helpful. my 2007 pt did same thing, engine light came on , car was jerking and bucking, ( had nothing to do with the a/c or heat) it was the cam positon sensor, on line the part is 35.99 to 55.99 depending on where you buy it, local garage did mine part and labor for 162.00 29 people found this helpful.
Can a bad sensor cause a PT Cruiser to spark?
Sensors go bad but it boils down to spark in the end result unless there is internal engine damage like a broken valve train component or something worse and likely catastrophic. 12 people found this helpful. Just a side note, even with the more modern vehicles it is still a good idea to check for weak vacuum lines.
Where is the engine code on a PT Cruiser?
When I restarted the engine, the codes were gone and the engine ran like it suppose to. When the cam sensor came I installed it anyway and now the car drives fine. If you turn the key on and off three time in a row, your engine code will be displayed where the odometer is located. No need to go to a shop! 19 people found this helpful.
What to do if your PT Cruiser has a problem?
The first and most common solution is to replace the cylinder 3 exhaust valves that are burnt. The other solution is to replace the injectors and map sensor. Other solutions owners have found to be helpful are changing out the camshaft position sensors, replacing the pressure switch.
Sensors go bad but it boils down to spark in the end result unless there is internal engine damage like a broken valve train component or something worse and likely catastrophic. 12 people found this helpful. Just a side note, even with the more modern vehicles it is still a good idea to check for weak vacuum lines.
When is the worst year for PT Cruiser problems?
In general, 2006 is the worst year for PT Cruiser problems. Here the engine light is constantly on and the engine idles rough. The engine light will repeatedly turn on after solutions to fix the problem are attempted.
Why does my 2002 PT Cruiser get hot?
Yo I’m having the same problem With my 2002 PT Cruiser. Only last time it almost over heat it actually was hot. The first time it did there was plenty of coolant in the reservoir and in the engine. It can’t be the water pump because I replaced it. I’m wondering if it is a bad thermostat or a fan causing my problems.. 33 people found this helpful.
Why is my PT Crusier engine shutting down?
Our PT Crusier has been dying while driving 55/60 mph. We thought fuel pump, but after letting the cruiser sit for 10 mins or more, it may start back up. This problem has been going on for about 2 mos or so. Battery is brand new and had fluids, oil, and a seal for transmission leak done in Feb. Of this year.
Why was my 2005 PT Cruiser GT misfiring?
Having two new sensors allows them to sync their info together better for the control module.
