What did the 904 transmission come in?
What did the 904 transmission come in?
The Torqueflite 904/999 series of transmissions were used in Jeep CJ, MJ and XJ models. The full size Jeeps used the more robust 727 Torqueflite transmissions. The Jeep 904 transmission was 1st used by Jeep behind the 4 cylinder CJ starting in 1980.
Are TCI Transmissions any good?
leaky transmission The TCI Trans works good. Had a lot of trouble with leaks around pan. It had a note to re torque the pan bolts during as they could loosen during shipping. I don’t think the transmission is checked for leaks before it leaves the factory.
Is the A904 transmission the grandfather of automatic transmissions?
The A904 transmission could very well be considered the grandfather of most of the Chrysler automatic transmissions to follow.
How big is the transmission on a Chrysler A904?
Transmission: A904: Diameter: 10 3/4″ Spline: 27: Pilot: 1.810″ Hub: Slotted: Mounting: 4 Pads: Clutch: NO ; Stall: CH: Notes: 120 grams weight
How many bolts are in a 904 transmission pan?
The 904 transmission pan has 14 bolts and is smaller and squarer than its bigger brother 727 unit. You will find a replacement A904 transmission in one of these many vehicles:
What kind of lock up converter does a 904 use?
All 904 transmissions up to 1977 had a hydraulic 10.5-inch converter, although the 1977 models used a low-slip converter of similar size. 1978 and newer 904s all used a 10.5-inch lock-up converter. The bellhousing bolt pattern is the same for all years; however, internals are slightly different, depending on the engine size of the donor vehicle.
What kind of transmission does a jeep 904 have?
The 909 is a 904 with a lock-up torque converter. The TF904 was used in CJs from 1980-1986 only with the I4 engine. From 1980-1983, the 904 had a Chevy engine pattern for the “Iron Duke” 2.5L. From 1984-1986 the 904 had an AMC pattern for the AMC 2.5L. The 904 was also used from 1984-1986 in XJs and MJs with the 2.5L and 2.8L engine.
When did Jeep stop using the tf904 transmission?
The TF904 was used in CJs from 1980-1986 only with the I4 engine. From 1980-1983, the 904 had a Chevy engine pattern for the “Iron Duke” 2.5L. From 1984-1986 the 904 had an AMC pattern for the AMC 2.5L.
Is the 904 transmission the same as the AMC 2.5?
The new engine had a different bolt pattern and with it the 904 transmission bolt pattern was also changed. The AMC 2.5/904 shares the same bolt pattern as the 60-degree GM bolt pattern. Jeep utilized this bolt pattern not only for their AMC 4cyl but also the Chevy 2.8 that Jeep used in their down sized XJ Cherokee.
When did AMC start using the TorqueFlite 904?
The new scaled down version would be known as the Torqueflite A-904 and it would find its way initially behind the Slant 6. Although not as strong as the 727, the A-904 transmission was deemed a complete success. AMC first started using the 904/999 Torqueflite transmissions in their passenger cars as early as 1972.
