What kind of wrench do I need for Toyota hub?
What kind of wrench do I need for Toyota hub?
OTC’s No. 7941 Hub Locknut Socket Wrench for select Toyota vehicles features rugged construction and a 1/2 inch square drive. This wrench is used to remove the 4-hole locknut on the inside face of the hub.
Do I need any special tools to replace a front wheel?
You really dont need any special tools the tool you may not have is the axle nut socket but they rent those at auto zone. You would just jack it up so the front wheels are off the ground let the car rest on jack stands. Before you do that make sure the ebrake is on and the car is on a level surface with the rear wheels blocked.
Can you remove a wheel lock without a tool?
Hey guys, if you buy a car with no wheel lock tool or you lost yours here is a video that will help you to remove the wheel lock without the tool and be able to remove your wheels. This procedure will work on most wheel locks.
Where are the pins on the toyoota hub?
The Wilmar W1272 pins are not located correctly for the Toyoota hub. The OTC fits perfectly and will hold up under the 203 ft lbs tightening torque required. The roll pins can be replaced if needed and if you use it all the time, I would suggest replacing them with solid pins.
How do you replace a wheel hub bearing?
Pry the steering knuckle off. Take the hub assembly and new bearing to a machine shop. They will use a special service tool to “press” the bearing and race into place. Once this is done, installation of all components is reverse of removal. Refer to the links below for proper torque procedures. Figure 10. Take the hub assembly to an auto shop.
OTC’s No. 7941 Hub Locknut Socket Wrench for select Toyota vehicles features rugged construction and a 1/2 inch square drive. This wrench is used to remove the 4-hole locknut on the inside face of the hub.
The Wilmar W1272 pins are not located correctly for the Toyoota hub. The OTC fits perfectly and will hold up under the 203 ft lbs tightening torque required. The roll pins can be replaced if needed and if you use it all the time, I would suggest replacing them with solid pins.
How much torque does a 2WD wheel bearing nut have?
Torque on 2wd front wheel bearing nut is about 200 ft-lbs, as the torque wrenched clicked a couple of the pins just broke off. Got the job done but a one time use $50 tool is useless. Works as intended after its modded for multiple use. I too received this socket with 4 roll pins.
