What is a bunker rake?
What is a bunker rake?
Designed by a golf course superintendent to be used with the “Aussie Style” of bunker maintenance. The tine-less or “toothless” rake has two sides, a smooth side to help pack down the vertical sides of a bunker, and a side with ridges to rough up the bottom of the bunker without leaving large grooves in the sand.
Where do you put bunker rakes?
But when rakes are left in bunkers, they are commonly left near the edge of the bunkers where slopes are common and the ruling complica- tions stated previously may arise. The best advice is to use common sense and place the rakes outside of the bunkers where they are least likely to affect the movement of the ball.
Should bunkers be raked?
Don’t toss rakes into the middle of bunkers, because you’re just a jerk if you do that. And don’t lay them in front of bunkers, because it could stop someone’s ball from going into the bunker. “The recommendation is to leave rakes outside of the bunker,” says Pagel.
Are rakes allowed in bunkers?
If rakes are left in the middle of the bunker, the only way to position them is to throw them into the bunker and this causes damage to the surface. Also, if a rake is in the middle of a large bunker, it is either not used or the player is obliged to rake a large area of the bunker, resulting in unnecessary delay.
Can you move a rake in a bunker?
Bunker rakes are considered movable obstructions. Per Rule 24-1b, your opponent must lift the ball, remove the rake, and take a drop as near as possible to the spot beneath its original position, then play without penalty.
Should you rake a bunker after using it?
After the shot has been played, the golfer should use a rake to smooth the sand in preparation for golfers following behind. Golfers should remember to smooth the sand and walk backwards out of a bunker to avoid adding extra footprints.
Do you have to rake the bunker?
When playing golf, if your ball lands in the bunker and you must shoot from there, good etiquette requires you to leave the bunker looking like it did before you visited it. This involves raking it back into good condition.
Why are there no rakes in bunkers?
But why no rakes? There are no rakes in the bunkers because of the conditions set forth by the Centers for Disease Control and the state of Florida, which require operating golf courses to remove shared surfaces used by golfers. One of those shared surfaces is a bunker rake, so they’ve all been removed from the course.
When can rakes go back in bunkers?
What happens if golf ball hits a rake?
A player’s ball is at rest against a bunker rake. The player moves the rake and the ball moves. There is no penalty and the ball must be replaced on the original spot.
What kind of rake does John Deere use?
To perform those jobs, John Deere has not one, but two fine options to help you complete the job. The 1200A is a gear-driven machine that set the standard for all bunker and field rakes when it was first introduced in 1995. And our 1200 Hydro gives you the excellent pulling and pushing power you expect from a hydrostatic machine.
What’s the speed of a John Deere bunker rake?
Speeds are variable in forward and reverse from 0 mph to 12.6 mph (0 km/h to 20.3 km/h), providing excellent raking quality at reduced ground speeds without sacrificing quick transport from bunker to bunker. Kanzaki is a U.S.-registered trademark of Kanzaki Kokyukoki Manufacturing Company.
Where is the neutral position on a John Deere field rake?
Neutral position is required for starting, and can easily be located by utilizing the bar welded to the foot platform. Also located to the left side is the lever for the differential lock. Simply engage by pressing down with the left heel.
