What are the trouble codes on a corvette?

P0141 Heated Oxygen Sensor (HO2S) Heater Circuit Bank 1 Sensor 2 P0151 Heated Oxygen Sensor (HO2S) Circuit Low Voltage Bank 2 Sensor 1 P0152 Heated Oxygen Sensor (HO2S) Circuit High Voltage Bank 2 Sensor 1 P0153 Heated Oxygen Sensor (HO2S) Slow Response Bank 2 Sensor 1 P0154 Heated Oxygen Sensor (HO2S) Circuit Insufficient Activity Bank 2 Sensor 1

How to reset the C5 DTC code on a corvette?

1) Turn on the ignition but don’t start the engine. 2) Press the RESET button to turn off any warning messages. 3) Press and hold OPTIONS. 4) While holding OPTIONS, press FUEL four times within a 10-second period. NOTE!! Only reset the C5 DTC Code IF you want to it’s NOT necessary to do this.

How do you find history code on Corvette?

First, consult the factory service manual. You should be into the CODES section of the DIC. The computer will automatically display all the codes your car has created. It will cycle through each code every 3 seconds. Any code that ends in H is a history code (something that has occurred in the past) but is fine now.

How to display C5 DTC code diagnostic trouble codes?

To display C5 DTC Code diagnostic trouble codes for all modules that transmit them. The Diagnostic Display Mode is entered with the following procedure: 1) Turn on the ignition but don’t start the engine. 2) Press the RESET button to turn off any warning messages. 3) Press and hold OPTIONS.

What is the C5 code for a corvette?

Corvette Headlight Motor Repair LS1, LS2, LS3, LS6 Head Removal C5 DTC (Diagnostic Trouble Code) list C5 Resetting Tire Pressure Sensors Reprogram Keyless Remote C5 Corvette Interesting Details Keep ahead of the game with our informative Here is an overview of the C5 Repair procedures and terms used for resetting codes.

Where do you find the DTC code on a corvette?

Each DTC consists of one letter and four digits, such as B0605, and corresponds to a specific error/fault. When a component or system is not operating within acceptable limits, the Corvette will activate the appropriate DTC and store it within the Body Control Module (BCM).

Hold the OPTIONS button down, and press the FUEL button 4 times. This will get you into the CODES section of the DIC. The computer will automatically display all the codes your car has created. It will cycle through each code every 3 seconds. Any code that ends in H is a history code (something that has occurred in the past) but is fine now.

What kind of engine is a Corvette LT1?

When both component numbers match, it is most likely a genuine LT1 350 c.i.d. The original LT1 must come from a 1970 to 1972 Corvette or Camaro Z28, however, not all Corvettes and Camaros have LT1 engines.

What are the specs of a 2002 corvette?

The 2001 Corvette coupe, convertible and Z06 models broke new ground in the areas of refinement, with better noise isolation, better idle quality, reduced maintenance costs and improved fuel economy. Greater emphasis on performance is further enabled with a standard Head-Up Display (HUD) for 2002 Z06 models.

Where is the casting code on a Chevy LT1 engine?

Remove one of the valve covers to access the cylinder head casting number. It is located on the cylinder head, usually towards the center. The casting code will be between six and seven numbers long and needs to be cross-referenced with a Chevrolet listing to verify it as a LT1 Cylinder head.

When did the Corvette LT1 engine come out?

The original LT1 must come from a 1970 to 1972 Corvette or Camaro Z28, however, not all Corvettes and Camaros have LT1 engines. The LT1 term was later used by Chevrolet during the 1990s as the Generation II LT1. Be sure of the year vehicle if the engine is still installed.

What is the engine ID number on a Chevy LT1?

Decode the LT1 engine ID number. In order, the code identifies assembly plant, month, day, and engine suffix code. When cross-referenced against a Chevrolet listing, the suffix code gives exact engine specifics.

What is the casting code for a LT1 engine?

The casting code will be between six and seven numbers long and needs to be cross-referenced with a Chevrolet listing to verify it as a LT1 Cylinder head. When both component numbers match, it is most likely a genuine LT1 350 c.i.d.

What to do when your Corvette C5 wont start?

Pull the correct fuses (found in the owners manual) and reset the codes. If that doesn’t work you can try this little trick: set the heat on high, shut the car off, discount the battery on the negative side, wait five minutes, reconnect and see if your problem has gone away.

What is the diagnostic code for a C5 Corvette?

C5 Corvette Diagnostic Trouble Codes (DTCs) & Descriptions (Non-Searchable) Diagnostic Trouble Code (DTC) Description. B0016. RIGHT FRONT/PASSENGER FRONTAL DEPLOYMENT LOOP (STAGE 1) RESISTANCE LOW. B0017. RIGHT FRONT/PASSENGER FRONTAL DEPLOYMENT LOOP (STAGE 1) OPEN. CIRCUIT.

Where is the ECM code on a 1994 Corvette?

1994-1996 Corvette ECM, CCM and ASR/EBTCM codes are accessed placing the jumper wire in ALDL connector positions 4 and 12. GM used numerals in place of alphas on all 1994 and up Corvettes at the ALDL. The ALDL numerals start with 1 in the upper left hand position and 9 in the lower left position.

What are the computer modules on a corvette?

Our inventory selection includes flash programming, body control modules, and remanufactured powertrain control modules, along with new electronic brake control modules, an ECM/PCM remanufacture service, and an EBCM rebuild service to fulfill your Corvette needs.

What are the best parts for a C5 Corvette?

Zip Corvette has the best quality Corvette Parts available for your 1997-2004 Corvette. Whether you’re maintaining or upgrading your 5th generation Corvette, our selection of C5 Corvette Engine and Performance parts is unsurpassed.

Can a Gen III PCM be used in a 2003 Corvette?

General Motors released several different hardware numbers to identify the 1-mb Gen III PCMs, but any of them can be used with an engine equipped with a 24x crank signal. All 2003-newer Gen III PCMs (excluding the 2003 Corvette) were fitted with additional flash memory capacity.

When do you need a new ECM for Chevy Corvette?

When you need a new ECM for Chevrolet Corvette, make AutoZone your destination. Your ECM makes fuel and ignition calibrations to deliver optimal engine performance, so addressing repair needs early is recommended. Head to AutoZone for the Chevy Corvette engine control module you need to get back on track.

How to check your Chevy Corvette engine control?

Use Code: DIYSAVE10 Online Ship-to-Home Orders Only Few vehicles boast the level of style and performance offered by your Chevy Corvette. If you’re experiencing starting problems or your check engine light stays on persistently, check into your engine control module.

What are the trouble codes on a corvette?