Is there a way to diagnose intermittent stalling?

Diagnosing an intermittent stalling problem can be a challenge, especially if the engine only stalls occasionally (and at the least opportune time). And if there are no pending codes, hard codes or history codes in the vehicle’s computer to give you some direction, you may find yourself guessing at a diagnosis.

Is there check engine light for intermittent stalling?

Many times, there will be no check engine light and no fault codes to give you a clue as to what might be causing the engine to stall. So the trick to diagnosing an intermittent stalling problem is to catch the vehicle when it’s acting up — and that rarely happens when you have the vehicle in your shop.

Can a stalling engine be intermittent driveability?

Intermittent driveability problems of any kind are always a challenge to diagnose. When a customer brings you a vehicle and complains of a stalling problem, you may not have much to go on other than their description of what’s happening and when it happens.

What should I check if my car is stalling?

If the vehicle is more than seven or eight years old the fuel pump would certainly be suspect. But, as with the idle speed control circuit; don’t replace anything until you’ve run some diagnostic tests. The first thing to check would be fuel pressure.

How can I tell if my car is stalling?

So the trick to diagnosing an intermittent stalling problem is to catch the vehicle when it’s acting up — and that rarely happens when you have the vehicle in your shop. You may have to keep the car and drive it for a few days to see if it stalls.

What causes a car to stall while idling?

STALLING DUE TO LOW FUEL PRESSURE If the engine stalls while idling or driving, the engine may be running out of fuel or not receiving enough fuel pressure to keep it running. The most likely cause of this kind of stalling would be a fuel pump that is not spinning fast enough or is intermittently cutting out.

Why does my car stall at highway speeds?

The engine may start and idle fine, but run out of power or even stall at highway speeds. If the engine starts right back up after stalling, the likely cause is low fuel volume delivery because of a weak pump. If the engine is running normally one minute, but suddenly quits, loss of ignition may be the problem.

What to do if your PT Cruiser is stalling?

Before troubleshooting any automotive issue, including stalling issues with the PT Cruiser, make sure that you check the vehicles trouble codes with an OBD2 scanner. Trouble codes are always a great place to start diagnosing problems on today’s modern computer controlled vehicles. Without them, you are in the dark.

What do you need to know about intermittent stalling?

And if there are no pending codes, hard codes or history codes in the vehicle’s computer to give you some direction, you may find yourself guessing at a diagnosis. Every engine needs three things to run and idle smoothly without stalling: a correct air/fuel ratio, sufficient idle speed for the idle load, and a good spark.

What should I do if my engine is stalling?

Cleaning the idle air bypass circuit in the throttle body with aerosol throttle cleaner; will often remove the gunk and solve your stalling problem. If a good soaking with cleaner fails to fix the stalling problem; check the wiring connector. It might be loose or corroded.

When to use a scan tool for intermittent stalling?

When attempting to diagnose an intermittent stalling problem, therefore, it is important to always use a scan tool to first check for any codes that might shed light on the condition, and secondly to look at all the essential sensor inputs to see if they are within range and are supplying accurate information to the PCM.

Why does my PCM stall when I Turn on the engine?

The MAP sensor senses intake vacuum, which the PCM uses to estimate load so it can adjust the air/fuel mixture accordingly. If the MAP sensor isn’t reading right, the PCM will receive bad information and possibly add or subtract more fuel than it should causing the engine to stall.

Why does intermittent stalling occur in a car?

One of the more unusual causes of intermittent stalling we’ve heard about is a defective vehicle speed sensor. When the vehicle stops moving, the PCM may not engage the idle speed motor (carbureted engines) or idle air bypass motor (fuel injected engines) so the engine will idle normally.

What causes a car to stall at 40 miles per hour?

The stalling typically occurs while decelerating at speeds below 40 miles per hour. The problem is caused by the calibration of the idle air control valve and evaporative emissions system.

What causes trouble shooting and maintenance of ICP-OES?

Worn pump tubing Blockage in nebulizer and/or torch Wrong wavelength choice – interferences Poor optimization – especially the neb. flow Choice of internal standard Insufficient stabilization time Standard preparation Incomplete digestion – particles in solution No matrix matching Wash-out (memory effects) 10

When to seek medical attention for increased intracranial pressure ( ICP )?

This dangerous condition is called increased intracranial pressure (ICP) and can lead to a headache. The pressure also further injure your brain or spinal cord. This kind of headache is an emergency and requires immediate medical attention. The sooner you get help, the more likely you are to recover. What causes ICP?

What are the signs and symptoms of an ICP?

These are the most common symptoms of an ICP: Headache. Blurred vision. Feeling less alert than usual. Vomiting. Changes in your behavior. Weakness or problems with moving or talking. Lack of energy or sleepiness.

What causes intermittent stalling on a Ford Escape?

Ford has also issued a recall (04S13) for 2001-2003 Ford Escape sport utility vehicles with 3.0L V6 engines for an intermittent stalling problem. The stalling typically occurs while decelerating at speeds below 40 miles per hour. The problem is caused by the calibration of the idle air control valve and evaporative emissions system.

Is there a way to diagnose intermittent stalling?