Why are my head lights not working in my minivan?

The problem lies in the FCM, BCM, or the multifunction switch. However, the FCM is the most likely culprit. If one of the lights does NOT work, then you have to check the green wiring connector located at the bottom of the IPM. You want to make sure you’re getting power through the IPM and into the wiring harness.

What’s the problem with the Chrysler Town and Country headlight switch?

Auto headlight switch (on)- auto switching from low beam to highbeam, headlights turn off 45219 mileage. See all problems of the 2011 Chrysler Town & Country . Tl-the contact owns a 2013 Chrysler town and country. The contact stated that while driving at 55 mph the low beam headlights seized.

Where are the headlight terminals on a Chrysler minivan?

The numbers start at the center and count upwards towards the driver’s fender. Attach a wire to the battery + terminal and touch the other end to terminals 3, 4, 5, and 6 one at a time. Check for headlight operation. Terminal 3 is the left low beam, 4 is the right high beam, 5 is the left high beam, and 6 is the right low beam.

Why is my Chrysler Town and Country AC not working?

While there are a variety of reasons your Chrysler Town & Country air conditioning won’t work, the most common 3 are a refrigerant leak, an electrical climate control issue, or a problem with the air conditioning compressor. What will be the outcome of an air conditioning system diagnosis?

What to do if your headlight doesn’t work?

One headlight works on low beam and another on high beam. Or the lights work erratically. Start your diagnostics by removing the FCM located in the IPM. You’re going to bypass that module and try to “hotwire” the headlights yourself to eliminate the possibility of a bad FCM. After you pull the FCM, look at the connector on the front of the IPM.

How does a headlight switch work on a car?

The headlight switch doesn’t actually do any switching. It’s built with a series of resistors. The switch has 12volts coming into it. As you move the switch, the resistors reduce the voltage, depending on where you set the switch—high beams, low beams, parking lights, flashers, etc.

Why is my headlight not working in my car?

This can be caused by no voltage to the lamps due to faulty relay, module, dimmer switch, headlight switch or wiring shortcoming. In order to unravel the cause of the problem, you can check the main fuse which is usually located in the engine compartment, particularly at the power center.

Is there a way to fix a faulty headlight switch?

It is not advisable to endeavor to fix wiring problems on your own. The Cause: Faulty relay, module, dimmer switch, headlight switch, etc. The Fix: Replace the faulty components.

How can I troubleshoot my hid headlight problem?

Here’s a way to troubleshoot HID headlight problems. But first, you have to understand how HID headlights work An HID ballast is a boosting transformer that converts battery voltage into the approximately 75 to 110 volts needed to maintain the arc. The ballast is designed to detect bulb shut down.

What to do when both head lights stop working at the same time?

When that happens, the operational lifespan of your headlight capsule will be severely compromised, and the only fix is to replace the headlight assembly. When both headlights stop working at the same time, the bulbs usually aren’t at fault.

Why are the lights flashing in my car?

When the CTM fails, it can result in flashing headlights or flickering headlights. Since there’s no actual headlight relay, most DIYers think it’s a bad multifunction switch as if it was the old days and the switch actually switched power. The truth is, this CTM can degrade and delaminate, causing all kinds of weird electrical behavior.

What causes headlights to flash when CTM fails?

When it senses a command for fog lamps it provide ground to the control coil of an externally mounted fog lamp relay located in the power distribution center. When the CTM fails, it can result in flashing headlights or flickering headlights.

How does the BCM work on a Chrysler minivan?

The switch has 12volts coming into it. As you move the switch, the resistors reduce the voltage, depending on where you set the switch—high beams, low beams, parking lights, flashers, etc. The BCM sees the reduced voltages and signals the FCM to switch the power on and off to the lights.

Why does my Dodge Grand Caravan not start?

It’s a less common cause for the problem, but the hard work to get to it is already done, My 2004 dodge grand caravan wouldn’t turn over. Replaced the battery, and still wouldn’t start. It ended up being the solenoid wire to the starter is loose. If I wiggle it, it will start. Looking to get a replacement wire. Was this answer helpful? Need help.

What does it mean when your headlights don’t work?

With that in mind, it can be tremendously useful to start off by looking at whether both, or just one, of your headlights have failed, and whether or not the high or low beam mode still works. When headlights stop working, it’s usually an electrical problem or an physical issue with the bulbs themselves.

Why is my Dodge Caravan not turning over?

Check the body ground under the battery tray and the wires leading to it. While the battery and tray are out of the way it’s an opportune time to remove the adjacent fuse and relay box and check the connectors underneath it for corrosion. It’s a less common cause for the problem, but the hard work to get to it is already done,

What causes your car headlights to not turn off?

Some of the issues that can cause car headlights not to turn off include problems with a: 1 Headlight switch 2 Multifunction switch 3 Daytime running light module 4 Light sensor 5 Relay 6 Grounded wire More …

How to disconnect a headlight from a car?

This can be accomplished in a handful of different ways: 1 Disconnect the battery. 2 Remove the headlight fuse. 3 Remove the headlight relay. See the next section for information about safely disconnecting a battery. 4 Your headlights should now be disconnected.

When did the 2001 Dodge Caravan come out?

Unveiled at the 2000 North American International Auto Show on January 10, 2000, the redesigned 2001 Dodge Caravan and 2001 Chrysler Town & Country were released for sale in August 2000. 2002 Dodge Cravan quit running at hwy speed. All instrument lights are working. No service engine light is on.

Why is the left side of my headlight not working?

LEFT RIGHT HEADLIGHT NOT WORKING FIX – YouTube WHY HEADLIGHT NOT WORKING. LEFT RIGHT HEADLIGHT NOT WORKING FIX If playback doesn’t begin shortly, try restarting your device.

Is there an electrical problem with my Dodge Caravan?

Re: Dodge Grand Caravan electrical problem with dash… Hi, I also have a Dodge Grand Caravan 2008 with similar problems.

What was the problem with the Dodge Grand Caravan dash?

One of the small wires broke inside the rubber boot between the door and body. The tech told me what he found and spliced the wires with a 50 cent connector. The guy was honest and “kudos” to Salsbury Dodge in Baton Rouge.

Where are the control wires in a Dodge Grand Caravan?

These wires are made to be bent, time and time again, as the drivers door is the most used. But there is a control module that is also located inside the drivers door and it uses a “twisted pair” of really small gauge SOLID wire (that goes back to the onboard computer).

Where can I Fix my Dodge Grand Caravan?

Here at south Jersey auto body we fix this issue .phone number is (609)-965-7850.I just fixed my 2009 grand caravan. I sodered new wire in so it doesn’t happen again. And srunk wrapped the wires.call us we will fix it.

Why are my head lights not working in my minivan?