Where is the fill hole on a Sebring top motor?
Where is the fill hole on a Sebring top motor?
4.The fill hole to the reservoir is on the left side of the pump as it is mounted. You must turn the pump/motor on its right end to allow it to be filled. Don’t overfill or damage to pump/motor may occur.
How to remove hydraulic motor from Sebring Touring convertible?
2.Remove the hydraulic pump/motor from its mounting location but don’t remove any lines (Refer to 23 – Body/Convertible Top/ASSEMBLY, Hydraulic – Removal) . 3.Remove the pump bracket and jute/cover that surrounds the pump. 4.The fill hole to the reservoir is on the left side of the pump as it is mounted.
How to check motor fluid level in Sebring touring?
Check the reservoir often while running the top up and down. 5.Fill reservoir up enough to allow it to run and fill up whatever was replaced or leaked out. 6.Operate the power top up and down and check/replace fluid until proper level is reached with the pump in the horizontal position. 7.Repeat Step #6 as necessary to reach proper fluid level.
Are there convertible top lift cylinders for Chrysler Sebring?
1 Pair (Drivers & Passenger Side) New Convertible Top Lift Cylinder for 1998-2006 Chrysler Sebring. These Lift Cylinders are an exact fit replacement for the original cylinders. This set includes 2 cylinders, 1 for the driver side and 1 for the passenger side.
4.The fill hole to the reservoir is on the left side of the pump as it is mounted. You must turn the pump/motor on its right end to allow it to be filled. Don’t overfill or damage to pump/motor may occur.
2.Remove the hydraulic pump/motor from its mounting location but don’t remove any lines (Refer to 23 – Body/Convertible Top/ASSEMBLY, Hydraulic – Removal) . 3.Remove the pump bracket and jute/cover that surrounds the pump. 4.The fill hole to the reservoir is on the left side of the pump as it is mounted.
How do you fill a hydraulic pump in a Chrysler convertible?
You can fill the pump slowly with a syringe or a squirt bottle through the fill plug in the middle, on top of the pump. You may need to use pliers or vise grips to loosen the plug if you end up stripping the 5-mm inside hex. The filling process through the fill plug is slow.
