How to repair and replace a Camaro Firebird?

Don’t bother with trying to buy one from a junk yard, the BCM is set up only to work with the car they are initially installed on. Start by disconnecting the negative (black) terminal on the car battery. Next, remove the passenger side kick panel and the panel under your glove box.

What’s the best way to repair a Camaro?

Wait for the solder to cool, and then give the circuit board a little shake to make sure the joints are no longer loose. Line up the pins on the back of the circuit board with the openings in the box, then reinsert the circuit board. Figure 2. Soldering these five joints tends to fix most BCM problems.

Do you need to replace the BCM on a Camaro?

Depending on the issue, you may not need to replace your BCM. There is a relay built into the BCM circuit board which often develops a loose joint. Pry open the BCM and pull out the circuit board. Turn the board over and look for cracks and loose joints; the red circle (in Figure 2) indicated the relay connection, which often goes bad.

What to do if your Camaro ignition key has been replaced?

If the new BCM does not automatically learn the chip in your ignition key, you may need to take the car into a dealer to have it programmed. Additionally, the BCM replacement may require you to reprogram the alarm and other electronic functions. If playback doesn’t begin shortly, try restarting your device.

What kind of engine do you need for a Camaro Firebird?

If your 4th gen F-body is in need of an engine and your are not quite ready to part ways with the car, this article will outline the best budget engine options available to get your car back up and running again. Perhaps the cheapest engine swap that can be accomplished on the Gen 4 Camaro/Firebird is the “Vortec” LM7/LM4 5.3L engine.

Where is the BCM on a Camaro Firebird?

Start by disconnecting the negative (black) terminal on the car battery. Next, remove the passenger side kick panel and the panel under your glove box. (C5 Corvettes have their BCM in the passenger footwell, under the carpet, under an access panel.)

What does the ODB reader on a Pontiac do?

Pontiac ODB reader is a unique code reader that basically assesses the on board computer of a car and assists in the retrieval of engine and electronic transmission codes as well as ABS codes. It is connected to your automobile’s self test connector and shows any problems on your check engine light.