How do you reset the parking brake on a Jaguar S Type?
How do you reset the parking brake on a Jaguar S Type?
RE: EPB Reset
- Reset the EPB module: a.
- Start the engine.
- Firmly apply and release the footbrake five times.
- Confirm that the message ‘NOT CALIBRATED’ or ‘APPLY FOOT AND PARK.
- Lightly press the footbrake pedal.
- Apply the parking brake by using the EPB switch.
- Release the parking brake.
- Release the footbrake.
What does park brake fault mean?
When your car is in park, your transmission is no longer able to move or turn. However, over time, the parking pawl can malfunction; thus making it easier for your car to continue moving even while in park. The emergency, or parking brake,was designed as an extra precautionary tool to make sure your car stays in park.
How do you release the parking brake on a Jaguar?
The EPB switch is located on the centre console. Operate as follows: With the ignition switched on, press the brake pedal, and press down on the EPB switch to release the EPB.
How do I reset my Jaguar S Type?
Press and hold the Trip switch, located on the end of the left hand side stalk. Wait one second. Press and hold the Reset switch, whilst still holding the Trip switch. The cluster should display (within three seconds) the warning message RESETTING SERVICE MODE.
Where is the parking brake on a Jaguar?
Jaguar Owner Information. The parking brakes operate on the rear wheels. Therefore, secure parking of the vehicle is dependent on being on a hard and stable surface. The switch which operates the EPB is mounted on the centre console, to the rear of the gear selector.
Can I drive with a broken parking brake?
Do not drive if parking brake is engaged If the parking brake release cable is broken, do not drive the vehicle. This can cause extensive damage to not only the emergency brake, but the entire braking system.
How do you reset the parking brake on a Jaguar XF?
To reset the parking brake, press and hold the foot brake. While holding the foot brake in position, move the parking brake switch to the ‘Apply’ position. [Hi, where can I find parking brake switch in jaguar xf 2012 pls?
How do you reset the computer on a 2005 Jaguar S Type?
Press and hold the Reset switch, located on the Trip Computer Switchpack. The reset switch has to be released immediately after the ignition is switched ON. Wait one second.
Why is my parking brake not working on my Jaguar?
Next is to check that the brake pads and cables are free and in good condition (pads not worn too far down) as these can cause fault indications. The fact that the park-brake still works and does not jam on or off would indicate that the major components are still working and may just need some attention and recalibrating.
What do you mean by parking brake fault?
Do you mean ‘parking brake fault’ This message can sometimes appear with low battery causing the electronic park brake to lose its calibration.
What to do if your parking brake does not come on?
Put the automatic gearbox in “parking” and push the parkbrake button down (i.e. to ensure it does not come on). Keep it pushed down and take the ingnition keys out of the it will not start the parkbrake motor. Whe you next get in the car, you will not see the “Park” light come on meaning the parkbrake is not on.
How often to release EPB on parking brake?
Apply and release the EPB five times to ensure no error is present. NB: It is also possible the actuator is bad though. Parking Brake Fault light is coming on?
