How long does it take to install ignition switch in 2001 Chrysler?
How long does it take to install ignition switch in 2001 Chrysler?
With a few tools, you can install a new ignition switch in your 2001 Chrysler, right at home. From start to finish, the job should take you 35 minutes to complete. Raise the hood of your Chrysler and remove the black cable from the battery, using a socket wrench.
Where are the retaining tabs on the ignition switch?
Press down on the two little retaining tabs on the top of the ignition switch–where they connect, at the bottom of the key lock cylinder. Pull the ignition switch away from its connection on the key lock cylinder.
How do you turn off the ignition on a car?
Plug the wiring harness back onto the ignition switch. Place the lower steering column trim back into position for mounting. Return each of its screws with the Phillips screwdriver. Tighten the screws a quarter turn past hand-tight. Do not over-tighten them, as you will crack the column trim. Turn the ignition off and remove the key.
What should I do if I need to replace my ignition switch?
Reconnect the cable to the negative (-) terminal on the battery, then insert the key into the ignition and turn it to start the vehicle. The vehicle should start without any issue. If it doesn’t, remove the ignition switch and reinstall it. Shut the engine off (if it starts) and disconnect the battery again.
How do you remove a battery from an ignition switch?
Use an appropriate sized wrench to loosen the nut holding the cable on the negative (-) terminal and then slide it off the post. You don’t need to remove the positive cable from its terminal. Tuck the negative cable to the side of the battery to make sure it doesn’t accidentally come into contact with the terminals.
What to do if your key is stuck in the ignition switch?
The key may be stuck in the ignition switch, but that shouldn’t stop you from turning it. If you don’t have a key, you will need to force the module to turn using a flathead screwdriver. Press the release pin inside the hole on the ignition module with a screwdriver.
How do you remove lock cylinder from ignition switch?
Push the lock pin in with a small screwdriver. This will allow the lock cylinder to withdraw from the ignition switch. Return the key to the off position and remove the lock cylinder from the old ignition switch. Slide the old lock cylinder into the new ignition switch.
With a few tools, you can install a new ignition switch in your 2001 Chrysler, right at home. From start to finish, the job should take you 35 minutes to complete. Raise the hood of your Chrysler and remove the black cable from the battery, using a socket wrench.
How do you reassemble a ignition switch?
Align the lock pin on the cylinder with the lock pin housing on the new switch. Turn the key to the lock position to make sure the pin locks the cylinder into the switch housing. Turn the key from the start position back to the accessory position. Re-assemble the ignition switch onto the steering column.
How do you remove the ignition switch on a Sebring?
If your Sebring is equipped with a loop antenna, remove this from the ignition switch as well. Remove the three ignition switch mounting screws with the tamper proof torx bit. Set these screws aside. Pull the ignition switch from the steering column until the column lock actuator is exposed.
