What should I do if my Sebring convertible malfunctions?
What should I do if my Sebring convertible malfunctions?
Going through all the connections to make sure there was no wires pinched or anything broken or loose, I decided to pull the manual trunk open handle. The bottom of the trunk popped out and the trunk was suspended by the two side mounts . I pushed the trunk back into the lock position and tried the “ top “ button . It worked !! The trunk closed .
Why is the top of my 2008 Sebring not going up?
2008 and the top is down and will not go up is there a way to get it up manually 11 people found this helpful. My 2008 had a trunk closing problem . Whether the top was being put down or put up the trunk would not close afterwards.
Where is the wire harness on a Chrysler Sebring?
The wire harness goes up the right arm ( for the trunk) and at the top makes a sharp bend. This is were I found the broken wire ( green with red tracer). You will have to remove the tape and the mesh. This problem started out intermittent and finally quit with the trunk up and the cover in the down position. I hope this helps .
Where are the switches on a Chrysler Sebring?
21 people found this helpful. This is the second switch below the other one,good luck 9 people found this helpful. it clears it, but when i push the button it comes right back no movement i am going to try it again tomorrow with someone hitting the button at the same time i am doing the switches with my finger will let everyone know
Going through all the connections to make sure there was no wires pinched or anything broken or loose, I decided to pull the manual trunk open handle. The bottom of the trunk popped out and the trunk was suspended by the two side mounts . I pushed the trunk back into the lock position and tried the “ top “ button . It worked !! The trunk closed .
2008 and the top is down and will not go up is there a way to get it up manually 11 people found this helpful. My 2008 had a trunk closing problem . Whether the top was being put down or put up the trunk would not close afterwards.
21 people found this helpful. This is the second switch below the other one,good luck 9 people found this helpful. it clears it, but when i push the button it comes right back no movement i am going to try it again tomorrow with someone hitting the button at the same time i am doing the switches with my finger will let everyone know
The wire harness goes up the right arm ( for the trunk) and at the top makes a sharp bend. This is were I found the broken wire ( green with red tracer). You will have to remove the tape and the mesh. This problem started out intermittent and finally quit with the trunk up and the cover in the down position. I hope this helps .
What was the problem with my 2007 Chrysler Sebring?
2007 Chrysler Sebring. Consumer writes in regard to airbag light switching on and off, brake light under trunk melted holding bulb and connection, and housing melted. Airbag light on dash panel starting flashing on and off. I was driving at the time. I stopped and turned off the engine to see when I restarted if it would stop but it did not.
Where is Chrysler Sebring general electrical system problems Part 1?
The contact called northland Chrysler Jeep Dodge at 248-398-8200 (located at 14100 eight mile rd, oak park, mi 48237) and the contact was informed that a diagnostic test was recommended. The manufacturer was made aware of the failure and did not assist. The vehicle was not diagnosed or repaired.
Why did my Chrysler Sebring battery stop working?
While driving various low speeds with the brake pedal depressed, the vehicle accelerated. The contact applied excessive force to the brake pedal to stop the vehicle. The vehicle was taken to an independent mechanic and the battery was replaced.
Where is the broken wire on a Chrysler Sebring?
After spending a lot of time, I found a broken wire ( green with red tracer) coming from that down position switch. The wire harness goes up the right arm ( for the trunk) and at the top makes a sharp bend. This is were I found the broken wire ( green with red tracer). You will have to remove the tape and the mesh.
