How much does it cost to replace a water pump on a PT Cruiser?

The average cost for a Chrysler PT Cruiser water pump replacement is between $760 and $921. Labor costs are estimated between $616 and $777 while parts are priced at $144. This range does not include taxes and fees, and does not factor in your specific model year or unique location.

Why does my 2002 PT Cruiser get hot?

Yo I’m having the same problem With my 2002 PT Cruiser. Only last time it almost over heat it actually was hot. The first time it did there was plenty of coolant in the reservoir and in the engine. It can’t be the water pump because I replaced it. I’m wondering if it is a bad thermostat or a fan causing my problems.. 33 people found this helpful.

Are there any problems with the Chrysler PT Cruiser?

Had all the same problems with overheating.Changed fan assembly,flushed out radiator etc.Ordered new after market radiator,installed runs better then new.Found out later they have a problem with small cores in radiator plugging up.Hope thi helps. 112 people found this helpful.

Where is the timing belt on a water pump?

The water pump is driven by an accessory belt at the front of the engine, or by the timing belt or timing chain. As the engine runs, this belt turns and keeps the pump working. What are the symptoms related to a bad water pump?

What happens if you have a water pump problem?

Leaking water pumps can result in damage to the drive and timing belts, and cause the engine to overheat. A failed water pump can be caused by other problems in the cooling system, such as a bad thermostat, radiator or head gasket. Can I drive with a water pump problem?

Do you need to replace the timing belt on a water pump?

For applications where the water pump is driven by the timing belt, the timing belt must be removed. Typically, this requires removal of the crankshaft pulley, timing belt covers, and timing belt tensioner. Once the new pump is installed, new coolant is added back while bleeding the cooling system of any air.

How is a water pump replaced on a Ford Ranger?

The replacement procedure will vary depending on whether the pump is driven by the timing belt, the serpentine belt, or chain. On a cold engine, the engine coolant is drained to a level below the water pump. Components that require removing to access the water pump are removed, including the belt or chain that directly drive the pump.

What should I do before replacing my water pump?

It is best to install a new cooling system thermostat when you install a new water pump, especially if the thermostat is old or original. Completely flushing the cooling system is a good idea when you replace the water pump. Flushing can be done before or after pump replacement.

Which is the lowest price Chrysler PT Cruiser parts?

We are your low price leader for OEM Chrysler Pt Cruiser parts. OEM Chrysler parts are manufactured by Chrysler to maximize the performance of Chrysler Pt Cruiser vehicles and provide the certainty that the repair will be done right the first time. Parts that fit. Parts that perform.

What kind of parts do I need for my PT Cruiser?

Original Chrysler Pt Cruiser Parts from the Mopar Parts Leader. Genuine Chrysler parts are the smart choice for repair, maintenance, or upgrade of your Chrysler Pt Cruiser . When you choose OEM parts for your vehicle, you’re choosing to maintain the quality and reliability of your vehicle, ensuring peak performance mile after mile.

What was the problem with my PT Cruiser?

I HAVE A 2007 PT CRUISER AND IT OVER HEATS BUT BLOW OUT COLD AIR, I DID CHANCH THE THERMOSTAT BUT IT STILL OVER HEATS WITH COLD AIR BLOWING OUT 144 people found this helpful. elizabeth, im having that problem, what did it end up being??

Where can I get genuine Chrysler PT Cruiser parts?

Genuine Chrysler Pt Cruiser Parts from Factory Chrysler Parts in Bartow, FL. Chrysler OEM Pt Cruiser Parts from Thunder CDJR. Genuine Chrysler parts are the smart choice for repair, maintenance, or upgrade of your Chrysler Pt Cruiser .

Which is the best part for a PT Cruiser?

Genuine Chrysler parts are the smart choice for repair, maintenance, or upgrade of your Chrysler Pt Cruiser . When you choose OEM parts for your vehicle, you’re choosing to maintain the quality and reliability of your vehicle, ensuring peak performance mile after mile.

Are there bells and whistles on a Chrysler PT Cruiser?

This car has no bells and whistles as well as no road noise reduction. While it is roomy inside any repairs outside requires removal of non related parts making self repairs a nightmare and too expensive to hire a mechanic.

Why does my 2006 PT Cruiser overheat?

2006 pt cruiser 2.4 turbo ho put on fail proof thermostat a month or two . Don’t not overheat on 20 mile drive but does on a longer trip. Radiator is full just notice coolant tank may be leaking could that be the only problem or something else? Cooling fan is working also. Is this a good question?

How does a water pump work on an Audi A4?

The pump housing has an impeller that circulates engine coolant through the cooling system passageways in the engine block and cylinder head, on to the radiator, where the coolant temperature is reduced. . The lower temperature coolant then flows back to the water inlet on the engine and the water pump continues the cycle.

Where can I get a compression test on my PT Cruiser?

Google-compression test, easy. Autozone will loan the tester.) both require you to get in there. You can pick up a used head at any salvage place (or have yours cleanedup) and order the head gasket on ebay (might as well do the valve cover/sparkplug tubes also). Good luck. 87 people found this helpful.

What to do if your PT Cruiser overheats?

1. Work on cool engine 2. Drain overflow tank. Pull off hose at tank site. Use a throwaway cup to catch antifreeze. 3. Put overflow tank hose back after draining to add mark. 4. Open bleeder valve 10 mm and remove overflow hose at radiator end. 5.

What should I do about my PT Cruiser overheating?

Checked debris between condensor and fan, fan works, coolant full, thermostat works, all relays good, changed egr valve and thoroughly cleaned egr tubing, no cracked head or head gasket problem. Getting to my wits end and ready to take long drive off short pier. Any ideas what’s wrong or what else I could do to fix this problem?

What kind of radiator does a Chrysler PT Cruiser use?

Keep it cruising into the sunset by maintaining its cooling system with an adequate amount of antifreeze from AutoZone. Your exquisite five-door hatchback depends on its Chrysler PT Cruiser radiator to protect your engine from the devastating effect of over-heating.

When to change the coolant on a PT Cruiser?

Notes: Always change your antifreeze coolant when installing a new radiator to prevent premature failure. Your nostalgic-looking PT Cruiser offers you all the freedom of personal transport that its name implies. Keep it cruising into the sunset by maintaining its cooling system with an adequate amount of antifreeze from AutoZone.

What happens when the timing belt breaks on a PT Cruiser?

To expand on guyiknow’s answer. PT Cruisers run semi interference engines. The path of the valves will not enter the path of the piston. It is possible for the exhaust valves and intake valves to contact at which point you end up with bent valve stems. My guess would be the determining factor is where the belt breaks.

Why do PT Cruisers have bent valve stems?

How can I tell if my water pump is bad?

The two most common signs of a bad pump are leaks and noises. Leaking water pumps can result in damage to the drive and timing belts, and cause the engine to overheat. A failed water pump can be caused by other problems in the cooling system, such as a bad thermostat, radiator or head gasket.

How much does it cost to replace a water pump on a PT Cruiser?