How much does it cost to replace fuel level sensor?

The average cost for a fuel tank pressure sensor replacement is between $281 and $330. Labor costs are estimated between $182 and $231 while parts are priced at $99. Estimate does not include taxes and fees.

How to test and replace a fuel level sensor?

How to test and replace a fuel level sensor. Because it’s an in-tank fuel pump, the hardest job is removing the fuel pump from the vehicle. Doing this test can help you pinpoint why the fuel gauge is not working. If this sensor is indeed working on your vehicle, then check the fuel gauge itself. This specific vehicle is a 2010 Subaru Impreza.

Where is the fuel rail pressure sensor located?

If you have some mechanical experience, replacing the fuel rail pressure sensor is a good DIY candidate. Note: Do not confuse the fuel rail pressure sensor with the fuel tank pressure sensor. The later is located inside or next to the fuel tank and requires a lot more time to replace.

How much does it cost to replace a fuel rail sensor?

We recommend Parts Geek or Advance Auto Parts for the best prices and selection. The cost of replacing a fuel rail pressure sensor depends on the make and model of your vehicle. However, on average, you can expect to pay anywhere from $130 to $210 for a replacement job like this.

How long does it take to replace a fuel pressure sensor?

Depending on the vehicle, it may only take a few minutes to replace the sensor but there is typically a one hour minimum. If you have some mechanical experience, replacing the fuel rail pressure sensor is a good DIY candidate. Note: Do not confuse the fuel rail pressure sensor with the fuel tank pressure sensor.

How do you install a fuel rail sensor?

Tighten up the mounting hardware to 12 inch pounds then a 1/8 turn. This will secure the fuel rail sensor to the fuel rail. Step 9: Plug in the fuel rail sensor harness to the sensor. Install any brackets that you had to remove to get the old sensor off.

What does the fuel pressure sensor all about?

What is the Fuel Pressure Sensor all about? In fuel-injected and diesel engines, fuel rail pressure sensors monitor the pressure in the fuel rail and report the reading to the engine control module. If any drop in pressure is detected, the engine control module compensates so that the fuel pump can restore the proper pressure.

How long does it take to change a gas level sensor?

Install a new gas level sensor by sliding it into the old one’s place. Repeat these steps from the last to the first in reverse to replace the unit in the vehicle tank and you are finished. It will require roughly two hours to reassemble.

How much does it cost to replace fuel level sensor?