How do you remove a clock spring from a car?
How do you remove a clock spring from a car?
The clock spring outer plate may need to be rotated slightly to access the screws. These screws are a number 15 Torx head. Using a Torx head screwdriver or socket to remove the mounting screws by turning them counterclockwise. Use caution as not to drop the crews down inside of the steering column.
How do you remove clock from steering column?
Using a small pick or screwdriver to release the plastic retainer clips while pulling the unit outward. This is required on some models. Gently work the clock spring back and forth and outward from the steering column shaft and gently remove.
Where does the clock spring go on a steering wheel?
4. Remove the Clock Spring: The clock spring sits over the center shaft of the steering column and is held in place by a set of small screws or plastic clips. Once the steering wheel has been removed do not rotate the clock spring upper plate.
What happens when you take off the clock spring?
If you are taking off the clock spring : Mark the clock spring and angle position sensor . If you rotate the angle position sensor when the steering wheel is off and then install the steering wheel. The car will think that you have the steering wheel rotated when you are driving straight.
How do you replace a clock spring on a car?
Complete the job by putting the alignment markers in place and then the steering wheel is ready to be re-installed and you are all set. Reconnect the batteries negative cable and you may need to clear the airbag trouble codes once the job is completed. Watch the Video! Here is a clock spring getting replaced along with a turn signal switch.
Can a clock spring be removed from an airbag?
This is required on some models. Gently work the clock spring back and forth and outward from the steering column shaft and gently remove. Electrical connectors are attached to the bottom of the airbag clock spring to transfer signals and controls to the steering wheel and airbag. This can also be a wiring harness on some models.
Can a clock spring be removed from a steering column?
Use caution as not to drop the crews down inside of the steering column. The top plate may need to be moved slightly in either direction to access all of the mounting screws. Once all mounting bolts have been removed gently grasp the clock spring and pull it from the column shaft.
What are the symptoms of a bad clock spring?
Symptoms of a bad clock spring include an airbag warning light on along with no horn operation. Also the radio or cruise controls may not work if they are mounted on the steering wheel. If you are doing the job yourself the part will cost between $55.00 and $110.00 (US) from Amazon depending on the manufacturer of the car.
