How do you make butterfly wings with wire?

How do you make butterfly wings with wire?

2 Method 2 of 2: Using Wire Hangers

1. Bend 2 wire hangers into the shape of butterfly wings.
2. Pull each of the hooks into a circle shape.
3. Push each wing into the leg of a stocking.
4. Knot each end of the stocking close to the hanger.
5. Wrap the hooks of the wings together to form the middle of the wings.

How do you attach cellophane?

Select the first piece of cellophane–the first shape on the upper left hand side–and brush glue on one side of it. Glue this piece down into it respective spot; again, use the rag to smooth out any air bubbles. Repeat this with all of the different colored cellophane shapes.

Can you melt cellophane?

Too much heat can melt your cellophane. So start at a lower heat than you think you need. Keep your iron moving and use it’s tip to iron in small detail areas.

How do you make fairy wings out of cellophane?

Cut out two pieces of cellophane that are large enough to cover one wing. Lay one of those pieces down, trying to keep it all flat. Spray on a layer of your spray adhesive. Put one of the wire wing frames on top of the now sticky cellophane and gently press it down.

How do you make wings out of wire?

Cut strips of wire and bend to make your wing veins. Wrap around them with floral tape and use the tape to secure them onto the frame. Cover the whole ting over with the floral tape and you should end up with something like this. but if you like to you can add loops onto the frame to pass ribbons through.)

What kind of wire do you use to make fairy wings?

To attach your two fairy wings together, bend a portion of your stronger wire (or old hanger) unto a U shape with a few inches extra on each side. As you can see, I used the same 12 gauge aluminum wire for this part– it worked ok, but using a stronger wire would’ve been MUCH better! You live, you learn.

Can you use galvanized wire to make wings?

Galvanized wire is not intended for prolong exposure as it as a Zinc coating that can cause poisoning , this is why Galvanized wire is not used in jewellery. Sometimes a set of wings to make can take 1-4 hours just for the wire frame to make.