Why does my badlander turn signal not flash?
Why does my badlander turn signal not flash?
Installed a badlander load equalizer 17 years ago for run and brake lights on the rear. If the bike is not moving the right turn signal functions correctly. If bike is moving, if you press the right turn signal, it will light up, but not flash. Looked in the service manual and this problem is not listed for troubleshooting the turn signals.
What does it mean when your turn signal does not flash?
Have a 97 FXDWG. Installed a badlander load equalizer 17 years ago for run and brake lights on the rear. If the bike is not moving the right turn signal functions correctly. If bike is moving, if you press the right turn signal, it will light up, but not flash.
Why is my turn signal not flashing on my Fatboy?
Had the same problem on a 99 Fatboy changed the ignition switch and problem was solved Have a 97 FXDWG. Installed a badlander load equalizer 17 years ago for run and brake lights on the rear. If the bike is not moving the right turn signal functions correctly.
Why are the turn signals on my hog not flashing?
Find the orange wire that feeds 12 volts to your turn signal module. Power it off of a breaker that is powered on, both 1 & 2 “clicks”. My speedometer is working erratic. When I give it throttle the speedimeter digital reading goes blank and the engine light comes on and the turn signals will not flash. When I come to a stop they work
What are the symptoms of a bad turn signal Flasher?
1. Turn signals or hazards do not function. The most common symptom of a bad or failing turn signal / hazard flasher is hazards or turn signal lights that do not function. If the flasher breaks or has any internal issues it can cause the lights to malfunction, or not respond at all when the turn signal lever or hazard light button are pressed.
Why are the lights on my dashboard not working?
Adjust the dial or knob to see if that fixes the problem. If the switch was accidentally bumped, your dashboard lights might have been turned off. Flip the switch or turn the dial or knob up and see if the lights on your dash come on or get brighter. If adjusting the switch doesn’t work, you may have a blown fuse or bad lightbulb.
What to do if your turn signal doesn’t work?
GO to E3. Check circuit between fuse and flasher connector, flasher and hazard flasher switch and between hazard flasher switch and bulb feed. REPAIR circuit wiring as required. CHECK hazard flasher switch, or turn signal switch, or turn signal switch assembly. SERVICE or REPLACE as required.
Had the same problem on a 99 Fatboy changed the ignition switch and problem was solved Have a 97 FXDWG. Installed a badlander load equalizer 17 years ago for run and brake lights on the rear. If the bike is not moving the right turn signal functions correctly.
