Where does terminal 87 connect to the fuel pump relay?

When the PCM energizes the ASD and fuel pump relays, terminal 87 connects to terminal 30. This is the On position. Terminal 87 supplies voltage to the rest of the circuit. The following procedure applies to the ASD and fuel pump relays.

Why is my cruise control not working properly?

Could be a transmission speed sensor. An ISS and an OSS sensor failure in the transmission can cause the vehicle cruise control to shutdown and not to function properly because the transmission shaft input and output data is not being sent to the ECM.

What should I do if my speedometer is not working?

Solution : If a bad sensor turns out to be the primary cause, the solution will most likely be to replace the wheel speed sensor. Behind the scenes of your speedometer, there’s a computer and electrical system that helps relay signals about how fast your car is moving, among many other things.

Where is the ASD relay on a Dodge truck?

kudran, yes it can. The ASD relay is located in the Integrated Power Module (IPM), in the engine compartment. Refer to label on PDC cover for relay location. To test the relay see if this helps. When the PCM energizes the ASD and fuel pump relays, terminal 87 connects to terminal 30.

Where are the relay boxes on a Dodge Durango?

It’s a 2007 Dodge Durango, 5.7L Hemi. It has the two relay like boxes on the driver’s side, with the TIPM (I guess, same number, P04692) toward the front. Initially had some strange issues. Found eventually a dead battery. That led to the need for a new alternator (low voltage when running).

Where is the starter relay on a car?

The starter relay location may vary depending on the vehicle type and model. It can be in the fuse box (also called a power box), the fuse panel under the dash, or on the right fender. Most cars will have it located under the hood, inside the long box with a black cover.

Which is the ground terminal on a fuse box starter relay?

The “S” terminal (or 85 terminal in some relays) receives a 12-volt signal from the car’s battery. A small current, usually less than 10 amperes, passes down the terminal and through the coil windings and through to ground. In the fender-mounted relays, this is the “I” terminal. In fuse box starter relays, the ground is terminal 86.

What’s the difference between a starter relay and solenoid?

While both components form part of the starting system, they are very different. The starter relay switches on the current that activates the starter solenoid. The starter solenoid, on the other handed, closes the switch for the starter motor and usually mounts on the motor.

What is the polarity of a starter relay?

However, the orientation or polarity does not matter as long as the relay does not use a diode. The cylinder types of starter relays feature connection posts. The two small terminals are the coil connections with one marked “S” and the other “I”.

Where are the fuses located in a Dodge Ram?

An integrated Power Module is located in the engine compartment near the battery. This center contains cartridge fuses and mini fuses. A description of each fuse and component may be stamped on the inside cover otherwise the cavity number of each fuse is stamped on the inside cover.

Is there an external fuel pump relay for a Dodge Durango?

Note that email is usually the quickest method. This solution is similar to Star case #S1308000399 and the official 2011-2013 Dodge Durango/Jeep Grand Cherokee recall where you’ll need to purchase an external fuel pump relay to take the place of the defective TIPM-mounted fuel pump relay.

Can a fuel pump be connected to a fuel relay?

To work properly, two conditions must be met: The fuel pump must be connected directly to the fuel pump fuse (fuel pump relay must come before the fuse slot). The easiest way to confirm this is to verify that no voltage exists on the fuel pump fuse when your vehicle is turned off.

Where are the fuses on a Dodge Ram?

Fuse box diagram (fuse layout), location and assignment of fuses and relays Dodge Ram 1500, 2500, 3500 (2002, 2003, 2004, 2005). Fuses protect the car’s electrical systems from short circuits. To check a fuse, look at the silver-colored band inside the fuse.

Can a tipm-7 fuse box accept a fuel pump relay?

A TIPM-7 fuse box can accept this external fuel pump relay since they contain the same faulty fuel pump relay that is soldered to the same TIPM circuit board. The bad thing about this solution is that it involves cutting, soldering, and heat shrinking several wires in multiple wire harnesses.

Where does terminal 87 connect to the fuel pump relay?