How do you fix a fuser on a Lexmark printer?

How do you fix a fuser on a Lexmark printer?

Replacing the fuser

1. Turn off the printer, and then unplug the power cord from the electrical outlet.
2. Open doors A and D.
3. Remove the fuser.
4. Unpack the new fuser.
5. Insert the new fuser.
6. Close doors D and A.
7. Connect the power cord to the electrical outlet, and then turn on the printer.
8. Reset the fuser maintenance counter.

Where is the fuser on a Lexmark printer?

The fuser unit/fuser assembly is the part of the printer that heats up to melt or “fuse” the toner onto the page. The fuser unit is located at the back of the printer, just inside the rear exit door.

How do I reset my Lexmark Fuser?

Press and hold and while turning the printer on. Release the buttons when the clock appears. CONFIG MENU appears on the first line of the display. Press until you see Reset Fuser Cnt, and then press .

How do you change a Lexmark Fuser?

Solution

1. Power off the printer.
2. Open the left side cover (also called door A).
3. Turn the two thumbscrews at each end of the fuser counter-clockwise.
4. Lift out each of the fuser hooks.
5. Using the fuser hooks, carefully pull the fuser unit out of the printer.
6. Remove the new fuser unit from the packaging.

How do I fix a fuser error on my printer?

Solution one: Reset the printer

1. Press the Power button to turn off the printer.
2. Disconnect the power cord from the rear of the printer.
3. Wait 30 seconds, and then reconnect the power cord.
4. Press the Power button to turn on the printer. Wait for the product to start.
5. Try printing again.

What is a printer fuser?

Definition of FUSER UNIT: A component found in electrostatic printers, laser printers, and xerographic printers and photocopiers. The fuser unit is used to permanently bond toner to a substrate by applying heat and pressure. A fuser unit is made up of two rollers; one to apply heat and one to apply pressure.

How do you change a fuser?

Follow the steps below:

1. Press the Power button to turn off the printer.
2. Open the Top Cover.
3. Unscrew the two long screws as shown to release the Fusing unit from the printer.
4. Remove the Fusing Unit from the printer by holding the handles on both sides.
5. Remove the Oil Bottle and the Fuser Cleaner from the Fusing Unit.

How do you reset the maintenance light on a Lexmark ms810?

To reset the maintenance count perform the following procedure:

1. Turn off the printer.
2. Enter the Configuration Menu.
3. Select Reset Roller Kit Counter from the Configuration Menu.
4. From the options displayed, select the roller kit to reset.
5. Select Yes to reset the roller kit counter value.

How do you reset a fuser?

Reset Fuser

1. Press the [Machine Status] button on the Control Panel.
2. Select the [Supplies] tab on the Touch Screen.
3. Select the [Fuser] button.
4. Select the [Reset Counter] button and then the [Yes] button to reset the Fuser.
5. Select the [Close] button to return to the default (Copy) screen.

What is a service fuser error?

A Service Fuser message means that the printer has detected some sort of problem with the fuser unit installed on this printer. The fuser unit is the part of the printer that heats up to fuse the toner onto the page. The meaning of the fuser error depends on the error code number associated with it.